Publicidad
Idiomas disponibles
Idiomas disponibles
120V WIRING DIAGRAM
GREEN
240V WIRING DIAGRAM
GREEN
1
I--
4.
The START/STOP
switch supplied with this Jointer/
Planer is a double pole switch. No changes are
required to the switch for 115/230-Volt operation.
5.
The 115-Volt plug supplied must be replaced with a
CUS/UL listed 230-Volt plug with ground.
6.
Re-assemble all the parts that were removed in
STEP 2.
GROUNDED OUTLET
CURRENT CARRYING
230 VOLT
__
GROUNDING
PRONG
The Jointer/Planer
is used to surface the faces and
edges of boards, produce a flat surface on warped
boards and shape rabbets, bevels, chamfers and tapers.
This Jointer/Planer
features an enclosed stand and
integral dust collection.
It also features a heavy cast iron
fence, infeed and outfeed tables to support long stock.
The fence tilts 45 degree in and out and has positive
stops at 90 degree and 45 degree in and out. The push
button industrial-style on/off switch has provisions for a
padlock lockout. One set of push blocks helps handle
stock. The Jointer/Planer easily handles rough-cut
lumber, and planes hard and soft woods up to 6 1/8"
wide using a three knife cutterhead.
DEFINITIONS
OF JOINTING
AND
PLANING
OPERATIONS
Jointing
Operations
- Jointing is a surfacing operation
in which a small amount of wood is removed from the
edges and faces of boards. These cuts are made to
straighten and to square an edge of a workpiece.
A
properly jointed board would have smooth, straight and
even surfaces so that the joint surfaces would fit
together perfectly, forming a seamless joint.
Planing Operations
- Planing refers to the sizing of
lumber to a desired thickness while creating a level
surface.
Rabbeting
Operations
- A rabbet is a notch cut into the
edge of a workpiece.
STARTING
AND STOPPING
JOINTER/PLANER
1.
The on/off switch is located in the front of the
enclosed stand.
2.
To turn the Jointer/Planer
"ON", press the green
start button.
3.
To turn the Jointer/Planer
"OFF", press the red stop
button.
LOCKING
SWITCH
IN THE "OFF"
POSITION
When the Jointer/Planer
is not in use, the start button
can be locked so that it cannot be started. Using a
padlock (included) through the two holes in the switch
and button.
15
Publicidad
