Hatco HEATMAX RCTHW2 Serie Instrucciones Originales página 10

OPERATION
General
Use the following procedure to operate HEATMAX Heated
Wells.
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.
NOTICE
Do not operate unit without water in well. Damage to unit
could occur.
Control Panel
The following are descriptions of the controls used to operate
the unit.
Power I/O (on/off) Button w/ LED
The Power I/O Button controls power to the unit. The LED
Indicator will illuminate green when the unit is on. The LED
Indicator will illuminate red when the unit is off.
Menu Button
The menu button allows adjustments of the holding
temperature.
Timer Button
The timer button allows adjustments of the timer. The timer can
be turned off or set between 1–180 minutes.
Auto-Fill Button w/ LED
The auto-fill button toggles between turning on and off the
auto-fill feature. When the LED Indicator is illuminated, the
auto-fill feature is on.
Hold/Heat Button w/ LED
The hold/heat button toggles between hold and heat mode.
• Hold Mode: The LED Indicator will illuminate yellow.
The display will show L 'XX'C, M 'XX'C, or H 'XX'C.
'XX' represents the current temperature of the unit.
• Heat Mode: The LED Indicator will illuminate red. The
display will show the HT XXC. 'XX' represents the
current temperature of the unit.
Up and Down Arrow Buttons
The up and down arrow buttons are used to make changes to
the settings.
Menu Button
Power I/O Button
Timer Button
Operating the Unit
Startup
1. For cord and plug units, plug the unit into a properly
grounded electrical receptacle of the correct voltage, size,
and plug configuration. See the SPECIFICATIONS section
for details.
• The Power I/O LED indicator will glow red when the unit
has power.
2. Prepare the well for operation.
• When not using the Auto-Fill function, make sure the
drain valve is closed, and manually fill the well with
hot tap water until the water is a maximum of 32 mm
(1-1/4") deep.
• When using the Auto-Fill function, make sure the drain
valve is closed.
NOTE: Do not operate the unit without water in the well. The
unit will overheat.
3. Press the Power I/O button to turn on the unit.
• The LED indicator will glow green when the unit is on
and heating.
4. Turn on the Auto-Fill function, if desired.
• Press the auto-fill button. The Auto-Fill function is on
when the indicator light is illuminated.
• The well will fill with water until the water reaches the
water level sensor in the well. During operation, the Auto-
Fill system will maintain the water level automatically
using the water level sensor.
BURN HAZARD: Some exterior surfaces on unit will get
hot. Use caution when touching these areas.
10
Up/Down
Arrows
Hold/Heat Button
Auto-Fill Button
Control Panel
CAUTION
RCTHW2CEM-0124