Worx Nitro WG737E Manual Original página 16

REPLACE BENT OR DAMAGED BLADE IMMEDIATELY.
WHEN SHARPENING THE BLADE:
1. Make sure blade remains balanced.
2. Sharpen blade at the original cutting angle.
3. Sharpen cutting edges on both ends of blade, removing equal amounts of material from both ends.
NOTE:
1. Be sure the mower is turned off.
2. Place the mower in stand up storage mode.
TO SHARPEN BLADE IN A VISE (SEE Fig. J)
1. Be sure the switch lever is released, the blade has stopped before removing the blade.
2. Remove blade from mower. See instructions for removing and attaching blade.
3. Secure blade J-1 in a vise J-2.
4. Wear safety glasses and be careful not to cut yourself.
5. Carefully file the cutting edges of the blade with a fine tooth file J-3 or sharpening stone.
6. Check balance of blade. See instructions for blade balancing.
7. Replace blade on mower and tighten securely. Refer to instructions below.
BLADE BALANCING (See Fig. K)
Check balance of blade by placing center hole in blade K-1 over a screwdriver shank K-2, clamped horizontally in
a vise K-3. If either end of the blade rotates downward, file that end. Blade is properly balanced when neither end
drops.
BLADE MAINTENANCE (See Fig. L1, L2)
Renew your metal blade after 50 hours mowing or 2 years, whichever is the sooner-regardless of condition.
Follow these procedures to remove and replace the blade. You will need garden gloves (not provided) and
a spanner wrench (not provided) to remove the blade. Hold the blade (21) and unscrew the blade bolt (20)
counter-clockwise using a spanner wrench, and then remove blade.
To re-assemble, position the blade (21) with the cutting edges towards the ground. Then securely tighten the
16
blade bolt (20).
ENVIRONMENTAL PROTECTION
Waste electrical products must not be disposed of with household waste. Please recycle where facilities ex-
ist. Check with your local authorities or retailer for recycling advice.
FOR BATTERY TOOLS
The ambient temperature range for the use and storage of tool and battery is 0 °C-45 °C.
The recommended ambient temperature range for the charging system during charging is 0 °C-40 °C.
Details regarding safe disposal of used batteries
At the end of the life of the appliance, remove the battery pack safely before disposing of the appliance. Do not
throw batteries away or throw them in the normal trash can. Also do not dispose of the battery with the machine.
Remove the used battery pack from the appliance and dispose of it at the nearest or convenient dedicated recycling
facility. If in doubt, consult your local environmental protection department. Batteries may enter water cycle if
disposed improperly, which can be hazardous for ecosystem. Do not dispose of waste batteries as unsorted
municipal waste.
7. TROUBLESHOOTING
WARNING: SWITCH THE MACHINE OFF AND REMOVE THE BATTERY PRIOR TO ANY
TROUBLESHOOTING.
Cordless Brushless Push Lawn Mower EN