Worx Nitro WX265 Manual Original página 17

4.INTENDED USE
This tool is intended for the fastening and loosening
of bolts, nuts and various threaded fasteners.
(included accessory as the screw bit is not suitable for
impactuse.)
5.OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
ACTION
BEFORE OPERATION
Checking the battery pack condition
Installing the battery pack
Removing the battery pack
Charging the battery pack
ASSEMBLY AND ADJUSTMENT
Assembling the hook and bit clip
Inserting the bits
Removing the bits
OPERATION
Forward / Reverse / Lock
WARNING: To prevent gear damage,
always allow the collet to come to a
complete stop before changing the
direction of rotation.
Start/Stop
WARNUNG: Do not excessively
operate at low speed, otherwise the
driver may overheat. If this occurs, cool
the driver by running it a high speed with
no load.
FIGURE
Variable three-speed
Press the speed adjustment button to
select preferred rotation speed, levels
1 to 3, with 3 being the fastest.
See Fig .A1
The operating speed will be illuminated.
See Fig. A2
In reverse rotation, auto stop mode is
engaged which will automatically stop
See Fig. A3
rotation when load is loosened adequately.
See Fig. A4
LED indicator
Before operation, gently squeeze the trigger to activate
See Fig. B1,
the LED light. After the trigger is released, the LED light will
B2, B3, B4 automatically turn off with a delay of 15s.
Both the impact driver and the battery are equipped with
See Fig. C1
protection systems. When the LED flashes (about once
See Fig. C2
every second, it will stop flashing when you release the
trigger), the system will automatically cut off the power
of the tool to prolong the battery life. If the impact driver
and battery pack are placed in the following conditions,
See Fig. D1,
D2, D3
See Fig. E
17