Descargar Imprimir esta página

Taurus HUBBLE 903912000 Manual Del Usuario página 11

Publicidad

are not misaligned or jammed and make sure there are no broken
parts or anomalies that may prevent the appliance from operating
correctly.
- Pay special attention when assembling and removing the acces-
sories, as the blades are sharp. Be careful and avoid direct contact
with the blades' cutting edges.
- Never leave the appliance connected and unattended if is not in
use. This saves energy and prolongs the life of the appliance.
- Do not use the appliance with pets or animals.
- Do not open the battery/ies under any circumstances whatsoever.
- Recharge the battery only with the USB power cord supplied by
the manufacturer, any other type of cable may cause explosion or
fire hazard. Do not use USB adapters.
- Use the device only with the battery/ies for which has been speci-
fically designed. The use of any other battery/ies s can cause an
explosion or fire hazard.
CHARGING THE BATTERY:
- Caution: a new battery is not fully charged and must therefore be
charged before the appliance is used for the first time.
- Charge the battery at an atmospheric temperature of between 4
and 40ºC.
- Connect the charger (7) to the jack using the socket on the
appliance. The socket is located at the lower part of the appliance.
- Plug the charger (8) into the mains.
- The pilot light (4) will blink to indicate that the charger is charging
the battery.
- Approximately 100 minutes are needed for a complete charge of
the battery.
- The pilot light (4) lights up permanently blue when the battery is
fully charged.
- When the battery is charged disconnect the charger from the
mains supply.
- The pilot light (4) blinks when the battery is running low. Once it
starts blinking, connect the appliance to the mains.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all products' packaging has been removed.
- Before using this product for the first time, it is important to make a
full charge of batteries.

Publicidad

loading