Publicidad
- WARNING: Detach the hand-held part from the supply cord before
cleaning it in water.
- Dismantle the appliance following these steps:
- Remove the guide comb (5) by using the comb release button (6).
- Hold the appliance with one hand and use the thumb to press
blades while holding the plastic part with the index finger until the
blades come out (Fig.3).
- Use the cleaning brush (9) to remove the hair from inside the
appliance and the blades.
- Clean the equipment with a damp cloth with a few drops of
washing-up liquid and then dry.
- Do not use solvents, or products with an acid or base pH such as
bleach, or abrasive products, for cleaning the appliance.
- Never submerge the appliance in water.
- During the cleaning process, take special care with the blades, as
they are very sharp.
- If the appliance is not in good condition of cleanliness, its surface
may degrade and inexorably affect the duration of the appliance's
useful life and could become unsafe to us.
- Clean the blade and the comb guide with the cleaning brush.
Remove the hairs from the blade and from inside the appliance
with the brush. It is important to clean off remaining hairs after
each use.
HOW TO REMOVE THE BATTERIES FROM THE INTERIOR OF
THE DEVICE:
- CAUTION: It is important that the battery is fully discharged prior
to its withdrawal from the apparatus.
- CAUTION: the appliance must be disconnected from the supply
mains when removing the batteries.
- To remove the batteries, once the life of the appliance, proceed as
follows:
- Open the top shell of the apparatus, removing previously with the
help of a screwdriver fixing screws. (Fig. 4)
- Identify the battery wires and cut their (Red and Black). To avoid
risks of a short circuit with a possible residual battery load, first cut
the Red wire and protect it by using insulating tape, then proceed
to cut the Black wire proceeding in the same way. (Fig. 5)
- Safely remove the battery from its housing.
Publicidad
