Hinkley ATOM 906030FHB-LDA Manual De Instrucciones página 14

INSTALLING THE BLADES
1 Attach the blades and blade arms using the three blade
attachment screws. Insert a blade attachment screws into the
blade arm, but do not tighten. Repeat for the two remaining
screws. (Fig. 1)
Tighten each screw securely starting with the center screw.
2
Make sure the blade is straight. Repeat these steps for the
remaining blades.
3 Fasten blade assembly to motor with provided screws and
lock lockwashers. Repeat procedure for remaining blades
(Fig. 2). Make sure screws are TIGHT! Loose motor screws
can contribute to unnecessary hum during operation.
Cordless power screwdrivers are NOT recommended,
as they usually strip the heads of the screws and
usually will not fully compress the lock washers on
the motor screws. Use a large flat blade screwdriver
for final tightening to fully compress the washers. This
will help ensure proper alignment of the blades and
noise-free, wobble-free running.
| hinkley.com
12
NOTE:
Screws
Blade arms
Fig. 1
Screws
Fig. 2
Blades
Blades