Publicidad
ConnectHose and Water Supplyto Pump
NOTICE DO NOT run the pump without the water supply
connected and turned on.
• Damage to equipment r esulting from failureto follow this
instructionwill voidwarranty.
4.
Run water through garden hose for 30 seconds to clean
out any debris. Turn off water.
NOTICE DO NOT siphon standing water for the water
supply. Use ONLY cold water (less than 100°F).
5.
Connect garden hose (not to exceed 50 feet in length) to
water inlet.Tighten by hand.
NOTICE Remove and discard the shipping caps from the
pump's high pressure outlet and water inlet before attaching
hoses.
1.
Uncoil high pressure hose and attach quick connect end
of hose to base of spray gun. Pull down on collar of
quick connect, slide onto spray gun and let go of collar.
Tug on hose to be sure of tight connection.
NOTICE Using a One Way Valve (vacuum breaker or check
valve) at pump inlet could cause pump or inlet connector
damage.
• ThereMUSTbeat leastten feetof unrestricted gardenhose
between the pressure washerinletandanydevice,suchasa
vacuumbreakeror checkvalve.
• Damageto equipment resulting from failure to follow this
instruction will void warranty.
_. WARNING
The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
• NEVERconnect high pressure hose to nozzle extension.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• Always be certain spray gun, nozzles and accessoriesare
correctly attached.
.
Similarly, attach other end of high pressure hose to high
pressure outlet (A) on pump. Pull down on collar of
quick connect, slide onto pump and let go of collar. Pull
on hose to be sure of tight connection.
.
Before connecting garden hose to water inlet, inspect
inlet screen (B). Cleanscreen if it contains debris or have
it replacedif damaged. DO NOTrun pressure washer if
inlet screen is damagedor missing.
,& WARNING Risk of eye injury.
Spray could splash back or propel objects
resulting in serious injury.
• Always wear indirect vented (chemical splash) safety goggles
marked to comply with ANSI Z87.1 when using or in vicinity of
this equipment.
• NEVERsubstitute safety glasses or dry-condition goggles for
indirect vented safety goggles.
6.
Turn ONthe water, press red button (C) on the gun and
squeezethe trigger to purge the pump system of air and
impurities.
Checklist Before Starting Engine
Reviewthe assembled unit to ensure you have performed all
of the following:
1.
Be sure to read Safety Rules and How To Use Pressure
Washerbefore using pressure washer.
2.
Make sure handle is in place and secure.
3.
Make sure shipping cap was removed and oil dipstick
was installed in pump.
4.
Checkthat oil has been added to proper level in engine
crankcase.
5.
Add proper fuel to fuel tank.
6.
Checkfor properly attached hose connections.
7.
Checkto make sure there are no kinks, cuts, or damage
to high pressure hose.
8.
Provide a proper water supply at an adequateflow.
10
Publicidad
