Publicidad
PRODUCT SPECIFICATIONS
Pressure Washer Specifications
Pressure .....................
3,800 PSI*
Flow Rate .....................
4.0 GPM
Detergent Mix .................
Use as directed
Water Supply Temperature .......
Not to exceed IO0°F
Pump Oil Capacity..............
12 fl. oz. (0.35 I)
Engine Specifications
RatedHorsepower ...............
13 at 3600 rpm
Bore ..........................
3.5 in. (88 mm)
Stroke .........................
2.5 in. (64 mm)
Displacement ...................
23.7 in. (389 cc)
Spark Plug
Resistor ....................
NGK BPR6ES
Set GapTo: ...................
0.028-0.031 in (0.70-0.80
mm)
IntakeValveClearance ............
0.15 ± 0.02 mm (cold)
ExhaustValveClearance ...........
0.20 ± 0.02 mm (cold)
FuelCapacity ...................
1.72 Gallons
Oil Type .......................
SAE10W-30
* This pressure washer is rated in accordanceto the
Pressure Washer Manufacturers Association (PWMA)
standard PW101 (Testing and Rating Performance of
Pressure Washers).
OWNER'SRESPONSIBILITIES
Follow the hourly or calendar intervals, whichever occurs
first. More frequent service is required when operating in
adverse conditions noted below.
MaintenanceSchedule
•
Changeengine oil
•
Check/clean waterinlet screen'
•
Check high
pressure hose
•
Check detergent siphoning hose
•
Check spray gun and assembly for leaks
•
Cleandebris
•
Check air filter
•
Check
engine
oil level
•
Cleanair filter 2
•
Change engine oil
•
Cleansediment cup
•
Check/adjust spark plug
•
Service
spark
arrester'
•
Clean fueltank and filter
•
Changepump oils
•
Replace air filteP
•
Replace spark plug
•
Check adjust idle speed4
•
Check adjust valve clearance 4
•
Cleancumbustion chambeP
•
Check fuel tube (replace if
necessary?
Cleanif clogged. Replaceif perforated or torn.
2
Service more often under dirty or dusty conditions.
3
Replacepaper element only.
4
These items should be serviced by your servicing dealer.
5
Changeafter first 50 hours of operationand then every 200 hours or 3 months,
whichever occurs first.
16
Publicidad
