Publicidad
Idiomas disponibles
Idiomas disponibles
12
Statement Information
12.1
FCC statement (applicable in US)
This equipment has been tested and found to comply with the limits for a class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
•
This device may not cause harmful interference.
•
This device must accept any interference received, including interference that may cause undesired
operation.
Any changes or modifications not expressly approved by Hilti for compliance could void the user's
authority to operate the equipment.
12.2
IC statement (applicable in Canada)
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada's licence-exempt RSS(s).
conditions:
•
This device may not cause interference.
•
This device must accept any interference, including interference that may cause undesired operation of
the device.
12.3
Radiation exposure statement (applicable in US)
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with greater than 20 cm between the radiator and your body.
12.4
Radiation exposure statement (applicable in Canada)
The product complies with IC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 10 cm between the radiator and your
body.
12.5
Radiation exposure statement (applicable in EU)
This device was tested for uncontrolled environment operations. To comply with RF exposure requirements,
a minimum separation distance of 20 cm must be maintained between the user's body and the product.
13
Further information
Accessories, system products and more information about your product can all be found → here.
*2401892*
2401892
Operation is subject to the following two
English
23
Publicidad
