Publicidad
Idiomas disponibles
Idiomas disponibles
Operation (cont'd)
Optional 02840 Shoe Group for
PVC-Coated Conduit Bending (cont'd)
9. Place the bender in COATED PIPE mode.
10. To bend 1/2" to 1-1/4" conduit sizes, rotate the
rollers to the raised position, as shown below.
11. To bend 1-1/2" and 2" conduit sizes, lower the
1/2" to 1-1/4" rollers and use the 1-1/2" or 2" rigid
rollers.
Greenlee Tools, Inc.
COATED PIPE and STANDARD PIPE Modes
By default the bender always turns on in the STANDARD
PIPE mode.
Whenever the optional 02840 shoe group for bending
PVC-coated conduit is used, the bender must be placed
in COATED PIPE mode. This ensures that the bend
angles displayed on the pendant will be accurate.
To enter COATED PIPE mode:
Raise to bend
1. Press and hold the CLEAR button on the pendant,
1/2" to 1-1/4"
sizes.
2. Continue to hold both buttons until the text
3. The two decimal points remain on while the bender
Lower to bend
1-1/2" and 2"
sizes.
To exit COATED PIPE mode or return to
STANDARD PIPE mode:
1. Press and hold the CLEAR button, then in addition
2. Continue to hold both buttons until the text
14
854DX Electric Bender
then in addition press and hold the ANGLE
SELECT q button.
"COATED PIPE" scrolls across the pendant and
the two decimal points " . ." on the pendant are on
continuously. The buttons must be held for approxi-
mately 2 seconds.
is in COATED PIPE mode.
press and hold the ANGLE SELECT q button.
"STANDARD PIPE" scrolls across the pendant and
the two decimal points " . ." on the pendant are
off. The buttons must be held for approximately
2 seconds.
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Publicidad
