Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance (cont'd)
d. Being careful not to impact the rollers with the
shoe hooks, carefully rotate the shoe 45° coun-
terclockwise so the drive hole and round center-
ing hub behind the sprocket are visible at the
12 o'clock position.
e. Continue to step 5.
4. Completely remove the shoe by following these
steps.
a. While pulling the lock pin, slide the shoe 1" away
from the sprocket.
b. After the shoe is unlocked, lift and remove the
shoe by performing a two-person lift, with one
person on each side of the shoe.
4455 Boeing Drive • Rockford, IL 61109-2988 • USA • 815-397-7070
©2019 Greenlee Tools, Inc. • An ISO 9001 Company
www.greenlee.com
Rotate shoe 45°.
5. Using the BEND or UNLOAD button, accurately
align the drive hole at the 12 o'clock position with
the round centering hub behind the sprocket.
Align this drive
hole with
centering hub.
This spoke
at 9 o'clock
position.
6. To reset and zero the bender, first press and hold
the CLEAR button on the pendant, and then in
addition press and hold the JOG button. Continue
to hold both buttons until the pendant displays "--",
which indicates the bender has been successfully
reset and zeroed. The buttons must be held for
approximately 10 seconds.
7. Reinstall the shoe, making sure the lock pin is
engaged and the shoe is locked.
USA Tel: 800-435-0786
Canada Tel: 800-435-0786
Fax: 800-451-2632
854DX Electric Bender
International Tel: +1-815-397-7070
Fax: 800-524-2853
Fax: +1-815-397-9247
Publicidad
