Bimar S110TT Folleto De Instrucciones página 9

Fax +32 030 9904733

•
A
ttention: when using electric appliances, the basic safety precautions must always be
observed to avoid risks of fire, electric shocks and physical injury.
• D
o not touch the heater with wet hands or feet.
•
D
o not expose the heater to the external weather conditions (sun, rain, etc.).
• T
hat the user must not leave the appliance unattended while it is connected to the supply.
•
D
o not move the appliance when it is in function.
•
I
f the appliance should fall over or shows signs of faulty operation, disconnect the electrical
cable immediately. Check that no part is damaged and switch it on after the appliance has
been thoroughly checked: in case of doubt, contact qualified professional personnel.
•
D
o not pull on the power cord or the appliance to unplug the appliance from the wall socket.
N
ever move the appliance by pulling the cord.
•
U
nplug the appliance when not in use.
•
T
hat the user must not leave the appliance unattended while it is connected to the supply.
• D
o not move the appliance when it is in function.
•
I
n order to avoid any risk of electrical shock, never immerse the plug, the mains cable and
the appliance in water or in any other liquid.
•
I
f the electric cord is damaged, it has to be replaced by the supplier or an authorized service center
or a professionally qualified, to avoid any risks.
•
N
ever use the radiator to dry damp garments.
INSTALLATION
• After removing the packing materials, check that the appliance is in perfect condition; if you are
unsure, do not use it and ask for qualified professional help. The packing materials (plastic bags,
polystyrene foam, nails, etc.) must be kept out the reach of children because they are potential
sources of danger; they must be disposed of in accordance with current law.
• Before connecting the appliance, check that the voltage shown on the data plate (220-240V~ 50Hz)
matches that of your local power supply and that the electric plug is grounded. In the event of
incompatibility between the electric outlet and the appliance plug, have the outlet replaced with
another more suitable type by professionally qualified personnel, who will make sure that the outlet
wiring section is appropriate for the absorbed power of the appliance. In general, the use of
adapters or extension cords is not recommended; if their use cannot be avoided, they must conform
to existing safety standards and their current capacity (amperes) must not be less than the
maximum appliance capacity.
• The appliance must be positioned at a safe distance from heating sources, inflammable materials
(curtains, cloth, etc.), inflammable gas or explosive materials and from materials that may be
deformed by high temperatures. Make sure that a space of at least 1 metre is left free in front of the
appliance, and 50 cm of free space at each side. Never use the appliance near a bath, a washbasin,
or a shower to prevent any danger of electrical shock, or in any positions where it can be pushed
and/or damaged. Never use the appliance in spaces of less than 4 m
or products are stored.
• Stand the appliance on a horizontal, flat surface or table; Never place the appliance on a sloping
surface as this can cause it to fall over. Never lay the electric cord under rugs or carpets.
• Make sure that the cable is positioned correctly, that it is not in contact with hot elements or sharp
edges, is not wound around the appliance, is not twisted, or in a position which can cause the
appliance to fall over. Check that the cable cannot cause tripping in order to prevent accidental
falls or injury to persons.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
9 32
/
Assembly page 9/32
2
or where inflammable liquids