GE 16 Manual Del Propietario E Instalación página 5

About storage drawer and cover removal.
GEAppliances.com
Not all features are on all models,
Humi_ity contro! Adjustable Humidity Drawer (on
some models)
Slide the control all the way to the Slide the control all the way to the LOW
.ic. Low HIGH setting to provide high humidity setting to provide lower humidity levels
recommended for most vegetables, recommended for most fruits,
Drawer and Cover Removal
Drawers can be removed easily by grasping
the sides and lifting up slightly while pulling
drawers past the stop location,
To remove the cover, lift it off its supports,
pull it forward, tilt it and take it out,
; III
/ /
i ¸ _-_
ii i
Twin Drawer Shelf
To remove:
Remove the drawers.
[2--] Reach in, push the front of glass cover up,
and atthe same time, pull it forward as far
as it will come.
Tilt it and take it out. Avoid cleaning the cold
glass cover with hot water because the extreme
temperature difference may cause it to break.
r_ Remove the drawer frame. (Always remove
the glass cover before you take out the
d ra wet fra me,)
Lift the frame off the supports at each side and
back, pull it forward, tilt it and take it out.
To replace:
_7] Lower the frame until it rests on the
supports at each side and back.
r_ Replace the glass cover, pushing its rear
edge firmly into the rear frame channel and
gently lowering the front into place.
r_ Replace the drawers.
About the automatic icemaker
A newly-installed refrigerator may take 12-24 hours to begin making ice.
Icemaker
Power Switch
Arm
in the STOP
Feeler Armin the (up) position
ON(down) position
Automatic Icemaker (on some models).
The icemaker will produce approximately
70-100 cubes, in a 24-hour period, depending
on the freezer compartment temperature, room
temperature, number of door openings and other
use conditions.
If the refrigerator is operated before the water
connection is made to the icemaker, set the
switch OH: or move the feeler arm to the STOP
(up) position.
When the refrigerator has been connected to the
water supply, set the switch OII position or move
the feeler arm to the O11(down) position.
The icemaker will fill with water when it cools to
15°F. A newly-installed refrigerator may take 12 to
24 hours to begin making ice cubes.
Once the icemaker stars to make ice, it may take
up to/48 hours to fill the bin, depending on the
temperature settings and number of door openings.
You will hear a buzzing sound each time the
icemuker fills with water.
Throw away the first few batches of ice to allow
the water line to clear.
Be sure nothing interferes with the sweep of the
feeler arm.
When the bin fills to the level of the feeler arm, the
icemaker will stop producing ice.
It is normal for several cubes to be joined
together.
If ice is not used frequently, old ice cubes will
become cloudy, taste stale, shrink or fuse together.
Icemaker accessory kit:
If your refrigerator did not already come equipped
with an automatic icemaker, an icemaker
accessory kit is available at extra cost.
Check the back of the refrigerator for the specific
icemaker kit needed for your model.