VONROC TC502AC Traducción Del Manual Original página 11

• Do not overload your tool. It is better and safer
to work within the indicated power range. Do
not cut materials other than tiles.
• Maintain your tools carefully. Keep the tools
sharp and clean in order to work properly and
safely.
• Follow the maintenance instructions and the
instructions for replacing the diamond blade.
• Stand safely and maintain your balance. Avoid
any unnatural body angles. Remain alert and
pay attention to your work. Use common sense.
Do not use the machine when you cannot
concentrate or when you are tired.
• If the replacement of the supply cord is
necessary, this has to be done by the
manufacturer or his agent in order to avoid a
safety hazard.
Full-length adjustable fence Fig. A, E)
The fence (3) enables you to cut parallel to the
cutting blade.
• Loosen the fence knobs (7) and set the required
distance.
• Tighten the fence knobs on both sides of the
cutting table (1).
• The markers determine the measurements (8).
Mitre guide (Fig.A, F)
Follow the same procedure for a straight/parallel
cut but use the mitre guide (21) against the fence
(3) for 45-defree cutting of tiles. Ensure that the
tile is held fi rmly into the guide before making the
cut.
Bevel angle adjustment (Fig. A, G)
The table surface has a variable setting between 0°
and 45° bevel angle.
• Loosen the bevel adjustment knobs (5) on the
front- and rearside of the table (1)
• Set the bevel angle by tilting the table (1) up
until you have reached the required tilt.
• Tighten the knobs (5) again on both sides of the
table.
Inspecting and replacing the diamond blade
(Fig. A, C)
• Cracked or distorted diamond blades must be
replaced immediately.
• Type of disk: diamond cutting blade with a
diameter of 180mm.
WWW.VONROC.COM
• Do not use blades that do not meet the
specifi cations in these instructions.
• Ensure that the diamond blade is secured
properly and rotates in the correct direction.
Replacing the diamond blade (Fig. C)
Disconnect the machine from the mains
electricity before replacing the blade
• Remove the water tray (4) from the machine.
• Loosen the blade guard's fi xing bolts (22) and
remove the splash guard (12).
• Loosen the blade fi xing nut (16).
• Remove the counter fl ange (15) and blade (2)
and push the new blade on the fl ange (14).
Consider the rotation direction indicated on the
blade. Attach the counter fl ange (15).
• Tighten the fi xing nut (16) and mount the
splash guard.
5. MAINTEN ANCE
Before cleaning and maintenance, always
switch off the machine and unplug the
power cord.
The machines have been designed to operate
over a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper machine care and regular
cleaning.
Cleaning
Keep the ventilation slots of the machine clean to
prevent overheating of the engine. Regularly clean
the machine housing with a soft cloth, preferably
after each use. Keep the ventilation slots free from
dust and dirt. If the dirt does not come off use a
soft cloth moistened with soapy water. Never use
solvents such as petrol, alcohol, ammonia water,
etc. These solvents may damage the plastic parts.
Always clean the tool immediately after use.
• Remove the water tray from the machine and
drain the dirty water.
• Unscrew the splash guard and clean it.
• Loosen the star-shaped knob, fold up the table,
and polish the entire machine.
EN
11