Descargar Imprimir esta página

VONROC TC502AC Traducción Del Manual Original página 9

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 34
Whenever using the machine
• Check that the switch is NOT in the 'ON/1'
position before connecting the machine to the
power supply.
• Always keep the power cord out of the way from
the moving parts of the machine.
Immediately switch off the machine when:
• The plug or power cord is defective or damaged.
• The switch is defective.
• You smell smoke or burning insulation.
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fi re, electric shock and personal
injury. Read the following safety instructions.
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate label.
Warning! An earthed power outlet is
required to safely operate this machine.
Do not connect the machine to unearthed
power outlets.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The minimum
conductor size is 1.5 mm
reel always unwind the reel completely. Do not use
unearthed extension cables.
2. MACHINE INFORMATION
Intended use
This tool is suitable for cutting various wall and fl oor
tiles with a maximum tile size of 500x500x35 mm.
The diamond wheel may be replaced by the user. It is
not permitted to use the tool for any other materials.
TECHNICAL SPECIFICATIONS
Model no.
Voltage
Power rating
Cutting disc no-load speed
Max. depth of cut at 90°
WWW.VONROC.COM
2
. When using a cable
TC502AC
230V~ / 50Hz
300W S1 / 600W S6 15%
2990/min
34mm
Max. depth of cut at 45°
Cutting angle
Cutting disc diameter
Cutting disc thickness
Table dimensions
IP rating
L
(Sound pressure level)
PA
L
(Sound power level)
WA
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-6.
1. Cutting table
2. Cutting blade
3. Fence
4. Water tray
5. Bevel adjustment knob
6. On/off switch
7. Fence knob
8. Measurement ruler
9. Riving knife screws
10. Riving knife
11. Blade guard
12. Lower blade guard
13. Riving knife plate
14. Inner blade fl ange
15. Outer blade fl ange
16. Blade fi xing nut
17. Motor axle
18. Machine
19. Small wrench
20. Large wrench
21. Mitre guide
22. Lower guard screws
23. Mounting holes
3. ASSEMBLY
Mounting the riving knife and blade guard
(Fig. A, B)
• Unscrew the two screws (9) slightly.
• Place the foot of the riving knife (10) under the
screws (and slightly under the table).
• Tighten the screws (9).
18mm
0-45°
Ø180mm x Ø22.2mm
2.2mm
360 x 330mm
IP44
87dB(A), K=3dB(A)
100dB(A), K=3dB(A)
EN
9

Publicidad

loading