Olimpia splendid 9K-12K Instrucciones Para El Uso Y El Mantenimiento página 14

REMOTE CONTROL
56° function
Only optional for some heating pump inverter
appliance.
To active this function, turn off the indoor unit
at first, then press
SWING
same time toward the indoor unit, until hear a
beep, and AC will appear on the remote
controller display and the indoor LED display.
1. This function helps carry away the accumulated
dirt, bacteria, etc from the indoor evaporator.
2. This function will run about 30 minutes, and it
will return to the pre-setting mode. You can
press button to cancel this function during
the process.
You will hear 2 beeps when it's finished or
cancelled.
It's normal if there is some noise during this
function process, as plastic materials expand
with heat and contract with cold.
We suggest operating this function at the
following ambient conditions to avoid certain
safety protection features.
Indoor unit Temp < 86
Outdoor unit 41
It's suggested to utilize this function every
3 months.
WI-FI function
Pressing the ECO button 6 times
activates the "Wifi" function, the
display shows "AP" waiting for
connection with the device.
To connect to the Wi-Fi network and
use the App, refer to the attached
Wi-Fi manual.
and SWING button at the
o o
F (30 C)
o o o
F (5 C) < Temp < 86 F (30
o
8 C heating function
1. Long press ECO button over 3 seconds to active
this function, and
the remote display.
Do it again to deactivate this function.
2. This function will auto start the heating mode
when the room temperature is lower than 8
o
(46 F), and it will return to standby if the
temperature reaches 9
3. If the room temperature is higher than 18
o
(64 F), the appliance will cancel this function
automatically.
I SET function
Remember your favorite setting and run into it by
press One button
Remember the favorite setting:
1. In each mode (COOLING/ HEATING/ FAN/ DRY),
long press " I SET " button over 3 seconds to
remember it;
2. When "AU" flashing appears on the remote
controller display, that means the remote
controller remember your favorite setting;
* Press any button to quit, and you can reset it
o
C)
by repeat 1, 2 operation.
Run into the favorite setting:
1. In each mode (COOLING/ HEATING/ FAN/ DRY),
one press " I SET " button to active;
2. The appliance will run as your favorite setting
and you will see [AU] flashing on the remote
controller;
3. Press it again or other buttons to cancel this
function.
12
o o
8 C ( 46 F ) will appear on
o o
C (48 F).
o
C
o
C