Publicidad
Idiomas disponibles
Idiomas disponibles
Installation instructions
Genuine parking distance control, Audi Q3 2015 ®
Included:
1x Control unit
◆
1x Buzzer
◆
4x Sensors
◆
4x Covering rings
◆
1x Mounting material
◆
Required special tools, testing and measuring equipment and auxiliary equipment:
Flat-headed screwdriver
◆
Phillips head screwdriver
◆
Side cutters
◆
Hand drill
◆
Set of spiral drill bits
◆
Forstner bit or step drill ∅ 20
◆
Triangular file
◆
Installation process:
Note
The Genuine Park Distance Control system should be fitted by an authorised workshop. Incorrect fitting may result
◆
in damage to the vehicle or the Park Distance Control system.
The work to be performed on the vehicle, as described in these installation instructions, may vary in some
◆
circumstances as a result of model improvement measures. As such, changes to the wiring colours or even the
fitting locations cannot be discounted. In view of this, please ensure that you always use the appropriate current
circuit diagram or the current vehicle workshop manual.
Subject to technical modifications.
◆
1.1 Painting the sensors
Page 1 - Figure 1
Note
The sensors only require painting in the car colour in the case of painted bumpers. If the bumpers are not painted,
◆
the sensors do not require painting.
The sensors must not be cleaned with silicone remover prior to painting. Use a mild alcohol such as industrial
◆
alcohol instead.
The sensors can be painted in the packaging in which they are delivered as this is designed to be used as a painting jig.
◆
Additional general information concerning painting:
◆
Self-study programme No. 214/215
The figure gives an example of the covering rings -1- already placed in the correct position on the sensors -4-.
Place the covering rings -2- on the rubber membranes of the sensors -3-.
Paint the sensors -3- and -4- evenly and not too thickly in the same colour as the car.
Carefully remove the covering rings -1- and -2- directly after painting (while the paint is still wet) using tweezers
and let the paint dry.
Repaint as necessary after drying (e. g. clear lacquer for twin coat painting).
Note
The covering rings -1- and -2- must be placed on the sensors -3- and -4- before any painting is carried out.
1.2 Marking and drilling the installation holes for the sensors
Switch off all consumers and the ignition and remove the ignition key.
Does not apply for Q3 S Line:
Page 2 - Figure 2
Note
The sensor installation holes must be drilled in the positions marked -arrow- on the inside of the bumper cover.
20
1x Power supply wiring harness
◆
1x Sensor wiring harness
◆
1x Fitting instructions
◆
1x Operating instructions
◆
Pencil
◆
Measuring and cutting tool
◆
Centre punch
◆
Round file
◆
Tweezers
◆
Scissors
◆
Wiring harness repair kit -VAS 1978-
◆
8U0 054 630 A
Publicidad
