Publicidad
Idiomas disponibles
Idiomas disponibles
Control Set
D DIP Switch (4)
DIP Switch 1
ON
DIP switch 1 is used to change the frequency. Two separate remote controlled devices can thereby be
operated in one room, without any problems of interference.
In this position, frequency 1 is selected.
1
2
ON
In this position, frequency 2 is selected.
1
2
DIP Switch 2
ON
DIP switch 2 is used to change between receivers 1 and 2. Two different receivers can thereby be
operated by one transmitter using the same frequency. In this position, receiver 1 is selected. Receiver
2 does not react to the signal.
1
2
ON
In this position, receiver 2 is selected. Receiver 1 does not react to the signal.
1
2
The receiver also has DIP switches. The positions of DIP switches 1 and 2 on the receiver and on the transmitter must match, in
order for any signal to be transmitted to the receiver.
D ON Button (2)
By pushing this button, the transmitter will be turned on. The LED (1) will light green.
If you do not move the joystick of the transmitter for a long period of time, the transmitter will automatically shut off to conserve
energy. You can then simply push the ON button again to turn on the transmitter.
D OFF Button (7)
By pushing this button for approximately 2 seconds, the transmitter will be turned off.
D Battery compartment (1)
The battery is located in this compartment on the reverse side of the transmitter. To insert or replace a battery, simply loosen the
screws and then take off the cover by pushing on the snap-in pin (arrow). The battery is attached to the connector with a type of
snap-fastener. Please be aware, that the connector can only be connected to the battery in a single position. After installing the
battery, replace the cover and tighten the screws.
GB+USA
11
Publicidad
