Descargar Imprimir esta página

fischertechnik PLUS CONTROL SET Manual De Instrucciones página 16

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 32
Control Set
8 Troubleshooting
Each green LED on the transmitter and on the receiver emits various code signals, which identifies the respective operating status.
LED on the Transmitter
LED is constantly lit.
LED flashes once per second.
LED flashes twice quickly, pauses, flashes
twice quickly.
LED does not light after switching on.
LED on the Receiver
LED is constantly lit.
LED flashes once per second.
LED flashes twice per second.
LED flashes four times quickly, pauses, then
flashes four times quickly.
The receiver receives no data.
LED does not light after switching on.
The servo does not work.
9 Important Information
Instructions for Environmental Protection
Do not put the electrical and electronic components of this construction kit in the household waste. At the
end of their service life, take them to a collection point for the recycling of electrical and electronic devices.
The symbol on the product, packaging or the instructions shows this.
Description
The battery voltage is OK. The transmitter is operational.
Data is being sent to the receiver.
The battery is almost empty and must be replaced. The full transmission range cannot
be guaranteed.
The battery is empty or the battery connection was incorrectly attached. The transmitter
is defective (please contact fischertechnik service team).
Description
The battery voltage is OK. The receiver is operational.
Data is being received from the transmitter.
The battery is nearly empty or the power supply is too low.
Short circuit in the wiring or a motor is overloaded or blocked. The motor outputs are
automatically switched off.
Transmitter and receiver are possibly not set to the same frequency. DIP switches 1 and
2 on the transmitter and receiver must correspond.
Power supply is out of order, or the power supply was incorrectly attached (backwards
poles). The receiver is defective (please contact fischertechnik service team).
Servo connection was incorrectly attached to the connector on the receiver.
See Fig. 2 on Pg. 1.
GB+USA
15

Publicidad

loading