Beta 3030H/2T Instrucciones página 7

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
Other limits in range of application include environments having combustible materials that could ignite due
to static electricity.
The device should not be used around molten metal,acids, radiating materials and brittle loads that could affect
The product shall be used indoor only to avoid wind pressure.
on the jack or possible hydraulic leaks from the device will contaminate the food.
Can not be used on sea ships.
Any spillage of oil, please stop use and connect manufacturer at once for help.
The manual forces required to move this device can be accomplished by the operator with no assistance
required. The handle operating force required to life the majority of vehicle lifting applications falls within
the Standard. Additional handle force may be necessary to lift heavier loads and may require assistance.
Any blockage, please stop use and connect manufacturer at once for help.
Do not work under a raised vehicle, if this is not supported by any stands.
PERSONNEL SAFETY
or medication.
• HANDLE THE JACK WITH THE GREATEST CARE WHILE PERFORMING ANY OF THE JOBS IT HAS BEEN
• The jack is a lifting device; do not use it to support the load. After lifting, support the vehicle with suitably sized
stands before working.
• Do not exceed the carrying capacity of the jack stated in the TECHNICAL DATA table.
•
• Check that nobody is in the vehicle to be lifted before operating the jack.
• Do not place any part of the body under the vehicle while lifting or lowering it.
HYDRAULIC JACK USE AND CARE
• Before each use, visually inspect the jack, checking that there are no surface defects, including deformations,
cracks, rust or cuts that may prevent the jack from being properly operated.
• If the jack is not used for prolonged periods, before using it, check that it is perfectly serviceable.
• Perform extra checks following any particular events that may have caused the jack to be damaged,
• thereby affecting proper operation.
• VPeriodically check the oil level. Remove the oil plug, check the oil level, and add oil as needed. Do not
• dispose of oil into the environment.
•
to malfunction
• Do not leave any pressure in the jack at end of stroke when there is no load.
• Store the jack in a suitable place when not in use.
• It is absolutely forbidden to make any structural changes to the jack, as these might affect its safety characteristics.
EN I
7