How to Start:
1.
Place On/Off switch to "OFF".
2.
Plug the power cord into the
grounded outlet.
NOTE: Before turning the inflator on
know the desired pressure (measured
in PSI).
3.
Place On/Off switch to "ON" to
start inflator. If using the pressure
gauge watch it closely and when
it reaches the desired pressure
place the on/off switch in the
"OFF" position.
IMPORTANT: Watch inflatable
carefully while filling; do not overfill.
NOTE: The pressure gauge on the
unit is for general reference only.
NOTE: When the unit has been
turned off, it is normal to hear air
being released from the unit. Remove
the universal valve adapter to prevent
pressure loss from the item being
inflated.
Cleaning
2.
Wipe plastic parts clean using
1.
Place the On/Off switch to "OFF"
mild soap and warm water.
and unplug the cord.
1.
2.
Set the On/Off switch to "OFF"
and unplug the cord.
Store accessories
in the storage
bag located on back of unit. The
storage bag has a smaller
compartment
to hold smaller
accessories.
Smaller
Compartment
4.
Coil the air hose around shroud
and snap into hose snap.
Hose Snap
5.
3.
Wind the electrical cord loosely
around the inflator and snap it
onto itself for storage.
Store the inflator in a clean and
dry location.
D30502
14_ ENG