Publicidad
Idiomas disponibles
Idiomas disponibles
7.
Place the pump on a hard, flat and stable surface. Place your feet on the pump's footrest and
begin pumping. If you are inflating the product for the first time, it may take more effort. It takes
about 5 minutes to inflate the product.
8. When the product is inflated, turn the gray end counterclockwise to release the pump.
9. Place the cap on the valve and turn it clockwise to close it. Use the valve wrench provided to
tighten the valve extra tight.
3.2 Attaching the fin
1.
Turn the product over so that the slot for
the fin is facing up.
2. Slide the fin into the slot.
3.
Take the attached pin and slide it through
the notch on the sides of the slot.
3.3 Attaching the ankle cord
Snap the ankle cord to the ring at the end of the product.
3.4 Assembling the paddle
1.
Press the pin on the rod of the lower part
of the paddle inward. Slide the upper part
of the paddle onto the lower part.
2. Rotate the upper part until the pin snaps
into the hole in the tube of the upper part.
3.5 Deflating
There are two ways to empty the SUP board: with the pump or manually.
3.5.1 Pump
1.
Remove the fin and place the product on a flat, stable and horizontal
surface.
2. Unscrew the valve cover.
3.
Make sure the valve pin is down by pushing it down and turning it
clockwise.
4. Attach the black end of the tubing to the pump on the side with the letters
"DEF".
5. Attach the gray end of the tubing to the product and twist clockwise to secure the tubing.
6.
Place the pump on a hard, flat and stable surface. Place your feet on the pump's footrest and
begin pumping. It takes about 5 minutes to pump the SUP Board empty.
7.
When the product is deflated, twist the gray end counterclockwise to release the pump.
8. Roll the product up to remove the last bit of air.
9. Place the cap on the air valve and turn it clockwise to close it.
22
1
2
Publicidad
