Publicidad
Clean and Replace Spark Plug
Change the spark plug every 100
hours of operation or once each year,
whichever comes first, This will help
your engine to start easier and run
better.
,030" (0,76 MM)
Wire Gauge
Resistor
PUMP
This screen filter should be checked
periodically
and cleaned if necessary.
1.
Remove filter by grasping end
and removing it from water inlet
of pump as shown.
2.
Clean filter by flushing it with
water on both sides.
3.
Install filter into water inlet of
pump
WAN D
If the nozzle becomes clogged with
foreign materials, such as dirt,
excessive pressure may develop,
If
the nozzle becomes partially clogged
or restricted, the pump pressure will
pulsate.
Clean the nozzle
immediately using the nozzle kit
supplied and the following
instructions:
1.
Shut off the pressure washer and
turn off the water supply.
2.
Disconnect
spark plug wire,
3,
Pull trigger on gun handle to
relieve any water pressure,
4.
Disconnect the wand from the
gun,
5.
Remove the nozzle from the end
of the wand with the
2mm allen
wrench provided as shown,
6,
7.
Clean the nozzle using the nozzle
cleaner provided or a
straightened
paper clip, Insert
into the nozzle end and work
back and forth until obstruction
is removed.
Direct water supply into nozzle
end to backflush loosened
particles for 30 seconds.
8.
Reconnect spark plug wire,
9.
Reassemble the nozzle to the
wand. Tighten securely to
prevent leaks,
10, Reconnect wand to gun and turn
on water supply.
11, Start pressure washer and place
wand into high pressure setting
to test.
1 7- ENG
D25852
Publicidad
