Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
Your generator
requires some assembly and is ready for
use after it has been properly serviced with the
recommended
oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator heIpline at
[-800-3
17-7833. if calling for assistance, please have the
mode[, revision, and serial number from the data tag available.
Remove
Generator
From
Carton
I.
Set the carton
on a rigid flat surface with "This Side
Up" arrows
pointing upward.
2.
CarefulJy open the top flaps of the shipping carton.
3.
Cut down corners
at one end of carton
from top to
bottom
and lay that side of carton
down flat.
4.
Remove
all packing material,
carton
fillers, etc.
5.
Remove
the generator
from the shipping carton.
Carton
Contents
Check all contents against those listed below:
• Main unit
• Engine oil
• Owner's
manual
• Engine manual
• Wheel
kit
If any parts are missing or damaged,
call the generator
helpline at 1=800=3 17-7833.
iNSTALL
WHEEL
KIT
NOTE:
While
the wheel
kit is designed
to greatly
improve
the portability
of your generator,
it is not intended
for
over-the-road
use.
You will need a 1/2" or 13mm socket
wrench,
a 1/2" or
13mm open end wrench,
a 7/16" socket wrench,
7/16" open
end wrench
and a needle-nose
pliers to install this kit.
NOTE:
Adjustable
wrenches
may be substituted
for open
end wrenches.
install the
I 0" Wheel
Kit as Follows:
I.
Place the bottom
of the generator
cradle on a flat,
even surface.Temporarily
place unit on blocks to ease
assembly.
2.
Slide axle through
both axle mounting brackets on
cradle frame, as shown in Figure I.
3.
Slide a wheel over the axle.
Cap Screw
Hex
Wheel
Handle Assembly
Use existing hardware
to attach left side of
support leg to unit
Support
Vibration
Hex Nut
Axle
_Cap
Screw
1_
Hex Nut
Cap Screw
Fiat Washer
/
E-Ring
Publicidad
