Maytag Precision Touch Control 800 Guía De Uso Y Cuidado página 6

Triple Zone F++iement with Power
Boost +m Option
The cookhg surface has one tripHeeHenlentwith Power Boost
TM
option Hocatedin the right front position. This dement can be
used for Hargercooking utensiHswhen the tripHeeHementis
used, or for smaHHer pans when the singHeor duaHsettings are
chosen.
To operate the ou
Melt
@
©
OFF
only, use the left
side of the
control knob and
select any setting
from Low to High.
Me(Jlur[! Low 2
To operate the dual or
triple dements, press the switch above the knob to the Heftfor
the tripHedement or to the right for the doubHedement. Then,
use the right side of the control knob to select any heat setting
from Low to High.
Power Boost
TM
Option
when the dual or triple elements are used, the Power Boost
TM
option can be seHected.This setting offers higher speed
cooking that can be used to quickHy bring water to aboi[ and
for [argo-quantity cooking.
Smoothtop Surface
Smoothtop Surface Notes:
+ Cooktop may emit
might
smoke and odor the first few
times the cooktop is used. This is normal
+ Smoothtop cooktops retain heat for a period of time
after the element is tamed off+ Turn the eHementsoff
a few minutes before food is compHeteHy c ooked and use
the retained heat to compHetecooking. When the hot
surface Hightturns off+the cooking area will+be coo+
enough to touch. Because of the way they retain heat, the
smoothtop dements will+not respond to changes in
settings as quickHyas coi+eHements.
+ In the event of a potentia+ boiHover,remove the pan from
the cooking surface.
+ Never attempt to lift the cooktop+
+ The smoothtop surface may appear discolored when it is
hot. This is norma[ and will[ disappear when the surface
coons.
Pans sholJ/d not extend mere than _/2to 7-&oh beyond
the cooking area.
When a controHis turned on, a gHowcan be seen through the
smoothtop surface. The element wimm cycle on and off to
maintain the preset heat setting, even o+1Hi.
For more information on cookware, refer to Cookware Recom-
mendations on page 7 and "Cooking Made SimpHe"bookHet
incHudedwith your range.
WARMING CENTER
ELEMENT
FLEX+CHOIC£ _M
ELEMENT
DUAL
ELEMENT
TRIPLE
ELEMENT
Hot Surface Light
The Hot Surface indicator Hightis Hocatedon the controH panel
The HightwiHH be iHHuminated when any cooking area is hot. It
wiHH remain on, even after the controHis turned off, untiHthe
area has cooHed=
Warming Center
Use the Warming Center to keep hot cooked foods warm, such
as vegetables, gravies and oven-safe dinner plates.
Setting the Control:
OFF
1. Push in and turn the knob. Warming
temperatures are approximate and are Max
indicated on the control as Min, 2-8
and Max. However, the control can Min 8
be set to any position between Min :
and Max. 2
@
2. When done, turn the centre[ to OFF and ,
remove food. The Hot Surface indicator Hight
will[ go off when the Warming Center surface has cooHed.
Notes."
+ Never warm food for longer than one hour _eggs for 30
minutes), as food quaHitymay deteriorate.
+ Do not heat coHdfood on the Warming Center.
+ Heat settings wiHH vary depending on type and amount
of food. AHways hoHdfood at proper food temperatures.
USDA recommends food temperatures between
140°-170° F,
Cooking Areas
The cooking areas on your range are identified by permanent
circHeson the smoothtop surface. For most efficient cooking,
fit the pan size to the dement size.
5