Fresmak ARNOLD CLASSIC Manual De Instrucciones página 9

A.- Operation of the vice.
For selecting the needed clamping pressure, fi t the handle at its lodgement and fi xing the handle turn
the "cylinder cap" (0086) making coincide the corresponding letter with the fi xed mark situated on the
spindle. Each number indicates a clamping pressure (see graphic) and if 0 coincide with the groove,
a mechanical pre-setting power it's applied.In this position, the pressure applied should not exceed
30N/m.
PROCEDURE:
- In the '0' position, the clutch is does not operate. (There is no 'click').
- To change the regulator position, the high pressure must be released.
- Each position has a fi xed stop. When this is reached, one must never apply additional pressure
on the handle.
- The handle must always be turned smoothly.
B.- Maintenance.
Should we notice that the unit or system sticks, blocks or does not work properly dismatling and deep
cleening will be needed. Follow the instructions below:
Dismouting: Take note of the location of the parts
1245)
1. Remove the ( and (
.
2. Remove seal (0087)
3. Remove the seeger circlip (1241)
4. Remove the cylinder cap (
5. Remove the dowel pin (
0083)
6. Remove the helix (
7. Take off the sloted case (
8. Remove the seeger circlip (
9. Push in the dowel pins (0020), untill they stick out of the coupling body (
10. Dismounting has fi nished.
Should the spindle not reach the high pressure for any reason, dissmanting and deep cleaning will be
needed. In order to do that, follow the C step.
90
80
70
60
50
40
30
20
10
0
0 1 2
Hidraulic spindle with regulator
0621)
. Pull out the spring and the ball.
.
0086)
and make sure the washer is inside
1240)
.
.
0084)
.
0016),
the clutch spring (
ARNOLD CLASSIC 125/160
3 4 5
NUMBER
0018)
and unscrew the torque rod (
4021).
ARNOLD CLASSIC 200
6 7 8
9
0085)
.
9 10