EINHELL TE-AC 18/75 Li OF Manual De Instrucciones Original página 18

7.1 Cleaning
•
Keep the safety devices free of dirt and dust
as far as possible. Wipe the equipment with a
clean cloth or blow it with compressed air at
low pressure.
•
We recommend that you clean the appliance
immediately after you use it.
•
Clean the appliance regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may be
aggressive to the plastic parts in the appli-
ance. Ensure that no water can get into the
interior of the appliance.
•
You must disconnect the hose and any
spraying tools from the compressor before
cleaning. Do not clean the compressor with
water, solvents or the like.
7.2 Condensed water (Fig. 2)
Important! To ensure a long service life of the
pressure vessel (2), drain off the condensed wa-
ter by opening the drainage cock (11) each time
after using.
Check the pressure vessel for signs of rust and
damage each time before using. Do not use the
compressor with a damaged or rusty pressure
vessel. If you discover any damage, please con-
tact the customer service workshop.
7.3 Safety valve (10)
The safety valve is set to the maximum permissib-
le pressure of the pressure vessel. It is not permit-
ted to adjust the safety valve or remove its seal.
It should be pressed from time to time to check
the function. To check the safety valve, carefully
unscrew the screw cap while the boiler is pres-
surized. When opening the cap, air will escape at
the valve. After you have opened the screw cap,
screw it back on completely.
7.4 Storage
Warning!
Pull out the rechargeable batteries and ventilate
the equipment and all connected pneumatic tools.
Switch off the compressor and make sure that it is
secured in such a way that it cannot be started up
again by any unauthorized person.
Warning!
Store the compressor only in a dry location
which is not accessible to unauthorized per-
sons. Always store upright, never tilted!
Anl_TE_AC_18_75_Li_OF_SPK13.indb 18 Anl_TE_AC_18_75_Li_OF_SPK13.indb 18
GB
7.5 Transport
•
Transport the equipment only by carrying it by
the transport handle.
•
Protect the equipment against unexpected
knocks and vibrations.
7.6 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com
8. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
- 18 -
11.10.2023 14:47:40 11.10.2023 14:47:40