To ensure the best performance, the filter cartridge should
be changed after 26.4 gallons / 100L. The maximum rated
capacity of the filter is 40 gallons/181.8L.
CARE & MAINTENANCE
• Water is a foodstuff. We recommend using the filtered
water within 3 days. If the appliance is not used for more
than 72 hours the water system will need draining. Unplug
appliance and take to the sink. Unscrew the drainage cap
located on the underside of the appliance and remove
the silicon bung over a sink. Allow all water to drain out of
the system. Re-insert the drainage bung and screw on
the cap. Repeat the process in section 3. First Use, to
refill the appliance to continue use.
• Should the appliance not be used for an extended period
of time (for example a holiday) we recommend that the
filter is removed and placed in a clean plastic bag and
stored in the fridge. This will help to maintain the filter
when not in use. Before using the filter after storage,
follow the preparation and fitting instructions for use as
normal.
• Do not overfill the water tank, do not fill above the "MAX"
fill to avoid risk of water overflow in the inner water tank.
• Any other servicing should be performed by an
authorized service representative.
4. How to use
1. Fill water tank to the "MAX" mark; water will flow through
the filter at a set rate and may take some time due to the
action of the filter cartridge.
2. Adjust the height of the drip tray to
accommodate the size of the mug
used. Ensure the drip tray is fully
engaged with the appliance. There are
3 height options (A).
3. Place mug or glass on drip tray (B).
4. Press the On/Off button (C).
5. Press the up or down button to select
the desired temperature and volume
settings (D).
6. Press the dispense button to start
dispensing. One beep at the start (E).
7. The dispense button will fade in and
out whilst dispensing and beep twice
once complete.
8. To engage the child lock, press and hold
the lock button for 3 seconds. The
lock button will change from white to
red (F).
Note:
• To stop the cycle at any time press the dispense button.
Once the cycle has stopped it cannot be continued. A
new cycle must be started.
• Sound - all remaining buttons can be turned off (not
sound in 6. & 7. in How to use guide, section 4.) by pressing
and holding the temperature down arrow and the volume
down arrow for 3 seconds in the locked mode.
• The refill icon will turn orange when the water tank needs
refilling.
• The filter icon will turn orange when the filter needs
replacing, at 26.4 gallons/100L usage, follow the filter
preparation and replacement instructions in this manual.
• Extension cords are available and may be used if care is
exercised in their use.
•
If an extension cord is used
(1) the marked electrical rating of the extension cord
should be at least as great as the electrical rating of the
appliance.
(2) the longer cord should be arranged so that it will not
drape over the counter or table top where it could be
pulled on by children or tripped over unintentionally.
(3) the appliance is of the grounded type, the cord set
or extension should be a grounding-type-wire cord
(applicable if grounding-type-3 cord is used).
5. Descaling
For safe & efficient operation of your Aurora appliance it is
important to descale regularly.
Untreated scale deposits prevent the element conducting
A
heat efficiently and may affect its performance.
The appliance will display the descale warning symbol when
the appliance requires the descale process.
Ensure the water tank is empty. Remove the filter and place
into a plastic bag and filter before starting the descale
B
process.
Descale Procedure:
1. Fill water tank with 105fl oz./3L of white vinegar
(minimum 4% acidity).
C
2. Place a 3 liter jug under dispense nozzle.
3. Press and hold the descale warning symbol for 3 seconds.
4. The descale warning symbol will flash and the appliance
will run a descale process. Caution: Dispense solution
will be hot; around 194°F / 90°C. When the water tank is
D
empty, refill with 70fl oz./2L of cold water and press the
descale warning symbol again.
5. The appliance will run a cleaning cycle. Caution:
Dispense solution will be hot; around 194°F / 90°C.
6. The descale warning symbol will turn off once complete.
E
7. Re-insert the Aqua Optima filter after descale process is
complete.
8. The appliance is now ready to use.
Note:
3
F
• To abort the descale process, press the dispense button.
Unless the process is run completely the de-scale
SEC
indicator will not be reset and the appliance will continue
displaying descale icon.
4