ulsonix LCLEAN MINI L Manual De Instrucciones página 30

The wash stops.
1. When the wash stops, the buzzer will buzz continuously for 6 times and then the power will be
automatically cut off.
2. Turn off the water tap.
3. Although the power can be cut off automatically, the power plug must be pulled out for the
safety.
Normal program.
1. Normal wash program is the easiest, most convenient and most common washing program. When
the user presses the power switch and then press Start/Pause button, the normal washing
program will start to work.
2. When the washer starts to work, the digital tube shows the remaining time. Time indicator light
which stands for remaining time is flickering.
NOTE!
1. Close the lid of the door when machine is running, otherwise it will automatically stops working
during spin process and send out abnormal warning.
2. The washer will not work when the filled water does not reach the set water level.
Function of automatic power shut off.
1. If the appliance does not start operating within 10 minutes of being switched on, it will switch off
automatically.
2. When the unit has finished working, it will emit 6 beeps and switch off automatically.
Function of adjusting for unbalance.
1. Uneven alignment of the laundry before spinning can cause vibrations during spinning. The
washing machine has an unbalance adjustment function. During operation, the washing machine
always automatically checks the operating status. If the vibration during spinning is too high, the
washing machine automatically starts the unbalance adjustment programme.
2. The washing machine can adjust the unbalance twice. If the adjustment does not work, an alarm
will sound.
End of program.
1. The washing machine will send off the special sound at the end of any program operation to
remind you to take out the laundry or operate it again.
2. After the sound, the washing machine returns to its power-off state with no display and all lights
off.
3. Please shut off the tap, pull out the plug when not in use to avoid water leakage or the fire
accidents.
Maintenance.
Use gentle clothing to wipe off the water and dirt on the surface each time after using the washing
machine. Detergent and other chemicals are not allowed to use to avoid any damage to the plastic
accessories.
Clean the water inlet.
After long time use, the water inlet mesh bag may y be blocked, and should be cleaned according to the
following steps:
1. Switch on the power, followed by shutting off the tap.
2. Let the washer works for 5 seconds so that water flows into the tub through the water inlet hose.
Then turn off the power.
3. Unload the water inlet hose and clean the mesh bag, then restore the water inlet assembly.
Clean Of the filter – various models.
After using the washing machine for a period, please clean it according to the following steps:
1. Take out the lint filter.
EN