Publicidad
Idiomas disponibles
Idiomas disponibles
Malfunction display and solutions.
Fault
Water injection for about
Alarm for
20 minutes.
water inlet.
Water valve fault.
Water level
Water level sensor loose.
sensor fault.
Alarm for
Open the cover when the
opening
washer is spinning or in
cover.
delay state.
Alarm for
The imbalance was
spinning.
checked for the third time.
Water drain time out 5
Drain alarm.
minutes.
Open the cover when
Child Lock.
entering the child lock
state.
•
Open and close the cover or press the start/pause button to access the fault information after the
fault has occurred. If the fault is still not cleared after the fault information has been removed, the
same problem may occur again in the next process.
•
If the voltage is too low, the washing machine may not operate normally. It can only be used when the
voltage is restored to normal.
Cause of fault
EN
Indication
El
Press "Start/Pause" button.
E2
Re-install the water level sensor.
E3
Close the cover.
Open the cover and shake off the
E4
clothes.
Close the cover.
E5
Open and close the lid one time.
Close the cover within 30 seconds or
E8
cancel child lock function.
Troubleshooting
Publicidad
