Publicidad
Idiomas disponibles
Idiomas disponibles
LED display description
Display
F
R
PRU
Er0
Er1
FAQ
Question
What should a beginner be aware
of?
How long is the guarantee?
Can I buy the handpiece sepa-
rately?
Which bit can I use? Only those
from the manufacturer?
Is the device suitable for removing
thick calluses on the foot?
Are the bits also suitable for acry-
lic and gel nails?
How long do nail drill bits last?
How to clean the bits?
04
Description
F means Forward/Clockwise rotating direction, it displays from F00 up to F30
(00 means no rotating speed, 30 means 30000rpm)
R means Reverse/Counterclockwise rotating direction, it displays from R00 up to
R30 (00 means no rotating speed, 30 means 30000rpm)
PRU means pause, tthe handle will stop running, press again to reactivate the
rotating speed.
Er0 means overcurrent protection. When the handpiece current suddenly
becomes too high, it displays Er0 with flashes, and the handpiece stops running to
protect the motor. The protection may not work if the current is too high.
Er1 means overload protection. It displays Er1 with flashes, and the handpiece
stops running to protect the motor. The protection may not work if the overload is
too high.
Answer
For a beginner, we always recommend starting with a low rotating
speed, then increase the speed slowly.
The guarantee for the nail drill is valid for two years. However,
you can always feel free to contact us if the machine has an issue
after two years, we are always at your service.
Yes, the handpiece can be ordered separately.
All bits with a diameter of 2.35 mm fit in the handpiece, 2.35 mm
is the standard size.
Yes, you can use the sanding bands to remove the thick calluses.
Yes.
It depends on the using times. The bits are consumer goods and
need to be replaced regularly.
The bits can be cleaned with a disinfectant spray.
Publicidad
