Metabo BHE 22 Instrucciones De Manejo página 12

END ENGLISH
7 Start of Operation
Before plugging in check to see that the
rated mains voltage and mains
trequency, as stated on the rating label,
match with your power supply.
7.1 Side handle installation
For safety reasons, always use the side
handle supplied.
Open the clamping ring by turning the side handle
(17) counter-clockwise. Place the side handle onto
the machine's collar. Insert the depth stop (7).
Tighten the side handle in the required angle
depending on the task at hand.
8 Use
8.1 Depth Stop Setting
Loosen the side handle (17). Set depth stop (7) to
ue oe drilling depth and retighten the side
andle.
8.2 Switching on/off
To start the machine, press the trigger (14).
The speed can be changed at the trigger.
This machine has an electronic soft start.
For continuous operation the trigger can be locked
with the tock button (13). To stop the machine,
press the trigger again.
If switched on continuously, the machine
continues running if it Is jerked out of
your hands. Therefore, always hold the
machine with both hands on the handles, stand
safety, and concentrate on your work.
8.3 Speed preselection (KHE 26 Contact)
Depending on the application, the optimum speed
is preset with the pre-selector wheel (8).
8.4 Operating mode selection
Select the desired operating mode by turning the
control knob (16). To tum, push the stop (15)
SN twist drilling
hammer drilling
DI (only with use of hammer drill chuck)
chiselling
ID (KHE 28, KHE 26 Contact, KHE 26,
HE 24 SP)
In chisel! mode the chisel is locked to be twist-
proof. To position the chisel for the particular
12
application, set the control knob (16) between
and Cm.
When a chisel is fitted, only operate the
machine in the chiselling operating
mode. CA
Avoid tevering movements of the
A machine when a chisel is fitted.
8.5 Selection of direction of rotation
A
Do not actuate the rotation selector
switch (12) unless the motor has
completely stopped.
Select direction of rotation:
R = clockwise
L = counter-clockwise
8.6 Drill chuck change (not KHE 24 SP,
BHE 22}
When changing chucks make sure that
the spindle is clean. Grease spindle
lightly if required.
Removing the chuck:
Turn chuck lock Di direction indicated by arrow
against the stop (a) and pull it off the spindle (b).
Replacing the chuck:
Place chuck onto spindie (6) (a). Tum chuck lock
(5) in direction indicated by arrow b) until chuck
de fully onto the spindle, then release the chuck
ock.
Check to see that the chuck is properly seated.