MELICONI AT 380 USB Instrucciones De Uso página 5

AMPLIFIED INDOOR ANTENNA
This symbol indicates that these instructions must be read carefully, especially the Safety Warnings,
which must be retained by the user for future reference and passed on to a new user together with the
product. Meliconi S.p.A. rules out any liability for injuries or damage caused to persons and/or objects
arising from the improper use of the product.
Model AT380 USB Meliconi amplified indoor antenna is able to receive and amplify digital
terrestrial TV signals and DAB radio signals in the VHF (band 3, 174~230 MHz) and UHF
(470~694MHz) bands.
The antenna can be connected to a TV set or a digital terrestrial decoder.
A
• This product is for use indoors only; do not use outdoors.
• Keep away from water: the device must not be exposed to drips or splashes of water.
Do not use in a damp environment.
• The product must not be exposed to sources of excessive heat, such as the rays of
the sun, fire or the like.
• To avoid electric shocks, do not tamper with the device or try to repair it.
• This product is not a toy, and must not be left within the reach of children or pets.
• Before connecting the devices, disconnect them from the mains electricity supply.
B
• Place the antenna in a suitable position, for example near a window and/or in the
direction of the TV broadcasting unit, away from metal objects, electrical equipment
and reinforced concrete walls, which would limit its function.
• Connect the cable of the Meliconi antenna to the antenna socket on the back of the TV
set or the digital terrestrial decoder (figure 1). If the decoder is fitted with an F-female
type antenna socket, use an F-male / IEC-female socket adapter (not included).
• To power the antenna, use the USB power cable included in the package; insert the
end with the jack plug in the 5V power socket at the rear of the antenna and insert the
other end with the USB connector in one of the TV ports (figure 2); it is also possible
to connect the USB cable to a standard certified power supply unit furnished with a
USB output (not included) and connect it to a 230V~ / 50Hz electrical socket (figure 2).
• Turn the knob (figure 3) to switch on the antenna and position it for maximum
amplification.
• Check that the antenna is switched on; the LED light should be on.
• Switch on the TV or decoder and select the desired channel.
AT380 USB
INSTRUCTIONS
Thank you for choosing MELICONI.
Safety warnings
Installation
GB
3