Descargar Imprimir esta página

LD Systems CE H30 Manual De Usuario página 6

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 35
ATTENTION:
1. Do not operate the device if it has been exposed to large temperature fluctuations
(for example, after transport). Moisture and condensation can damage the device.
Switch on the device only when it has reached ambient temperature.
2. Make sure that the voltage and frequency of the mains supply correspond to the values
indicated on the device. If the device has a voltage selector switch, do not turn the device
on until it has been set correctly. Use only suitable power cables.
3. To disconnect the device from the mains at all poles, it is not sufficient to press the on/off
switch on the device.
4. Make sure that the fuse used corresponds to the type specified on the device.
5. Make sure that appropriate measures have been taken against power surges
(e.g. lightning strike).
6. Observe the specified maximum output current on devices with Power Out connection.
Ensure that the total current consumption of all connected devices does not exceed the
specified value.
7. Replace pluggable mains cables only with original cables.
DANGER:
1. Danger of suffocation! Plastic bags and small parts must be kept out of reach of persons
(including children) with reduced physical, sensory or mental capabilities.
2. Danger caused by falling device! Make sure that the device is securely installed and
cannot fall down. Only use suitable stands or mounts (particularly for fixed installations).
Ensure that accessories are properly installed and secured. Ensure that all applicable
safety regulations are observed.
WARNING:
1. Use the device in the prescribed manner only.
2. Operate the device only with the accessories recommended and intended by
the manufacturer.
3. During installation, observe the safety regulations applicable in your country.
4. After connecting the device, check all cable routes to avoid damage or accidents,
e.g. due to tripping hazards.
5. Always observe the specified minimum distance to normally flammable materials!
Unless explicitly stated, the minimum distance is 0.3 m.
CAUTION:
1. Moving components such as mounting brackets pose a jamming hazard.
6

Publicidad

loading

Este manual también es adecuado para:

Ldceh30