MSW Motor Technics MSW-FBBD-150100D Manual De Instrucciones página 34

EN
SANDING DISC
SANDING OUTSIDE CURVES
Always sand outside curves using the sanding disc and moving the workpiece from the left side of centre,
as shown. Keep the curve pressed firmly against the sanding disc, moving the work evenly from the left
side of the sanding disc. Be sure to hold the workpiece firmly against the surface of the table.
MITRE GAUGE - DISC SANDER
A mitre gauge can be used on the worktable, as shown. The mitre gauge head can be set anywhere up to
60° (right or left) by loosening the lock-knob, setting the mitre gauge head to the desired angle, and
tightening the lock-knob.