Publicidad
Idiomas disponibles
Idiomas disponibles
SANDING SMALL SURFACES USING THE MITRE GAUGE
Use of the mitre gauge is recommended for sanding small end surfaces on the sanding disc.
NOTE: Always move the workpiece across the left side (dust chute end of machine) of the sanding disc and
be sure to hold the workpiece down tightly onto the table surface.
3.5.
Cleaning and maintenance
a)
Unplug the mains plug and allow the device to cool completely before each cleaning, adjustment or
replacement of accessories, or if the device is not being used.
Wait for the rotating elements to stop.
•
b)
Use only non-corrosive cleaners to clean the surface.
c)
Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
d)
Do not spray the device with a water jet or submerge it in water.
e)
Do not allow water to get inside the device through vents in the housing of the device.
f)
Clean the vents with a brush and compressed air.
g)
The device must be regularly inspected to check its technical efficiency and spot any damage.
h)
Use a soft, damp cloth for cleaning.
i)
Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or a metal spatula) because they
may damage the surface material of the appliance.
j)
Do not clean the device with an acidic substance, agents of medical purposes, thinners, fuel, oils or
other chemical substances because it may damage the device.
k)
Clean the machine, belt and disc after each use.
l)
Keep the machine dry, clean and free from oil and grease.
m) Store the tool in a safe and dry place, out of reach of children.
n)
During normal use, sanding belts and disc can become loaded with sanding debris. Use a stick belt
cleaner (available at most hardware stores) to remove build-up.
Caution: tool service must be performed only by qualified repair personnel, service or maintenance
performed by unqualified personnel could result in a risk of injury. When servicing a tool, use only identical
replacement parts. Follow instructions in the maintenance section of this service manual. Use of
unauthorised parts or failure to follow maintenance instructions may create a risk of electric shock or injury.
DISPOSING OF USED DEVICES:
Do not dispose of this device in municipal waste systems. Hand it over to an electric and electrical device
recycling and collection point. Check the symbol on the product, instruction manual and packaging. The
plastics used to construct the device can be recycled in accordance with their markings. By choosing to
recycle you are making a significant contribution to the protection of our environment.
Contact local authorities for information on your local recycling facility.
EN
Publicidad
