Elettro CONCEPT PROMIG 3600 Manual De Instrucciones página 10

•
Water unit (only with the optional cooling unit
560103
).
This function allows the setting of the cooling unit start-up. The
possible selections are: OFF – ON – AUTO, the default
selection is OFF. If "AUTO" is selected, when the machine is
switched on, the cooling unit starts, if the torch trigger is not
pressed after 30 seconds, it shuts off. By pressing the torch
trigger the group starts again and shuts off 3 minutes after
releasing the trigger.
• LCD Contrast
The adjustment may range from 0 to 100%.
This function can be used to increase or decrease the brightness
of display screen B.
To access this function, simply highlight it using the knob A and
press it for less than 2 seconds. The display screen B shows the
adjustment bar. The figure can be changed and confirmed by
pressing the knob A for less than 2 seconds.
• Factory OFF
The purpose is to return the welding machine to the original
default settings.
To access the function, simply highlight it using the knob A. By
pressing this for less than 2 seconds, the display screen B shows
the words OFF and ALL. By highlighting the word ALL and
briefly pressing the knob A reset is made and the display screen
B shows Factory Done!! This indicates the reset has been
successful. To return to the previous display page, simply press
the knob A for more than 2 seconds.
NOTE. For all the functions adjusted by means of the adjustment
bar, the initial default value can be reset.
This operation be performed by pressing the knob A for more than
2 seconds only once the adjustment bar appears on the display
screen B.
(Arc Length - Spot Time - Pause Time - Inductance, Burnback –
Soft Start - Pre Gas - Post Gas - LCD Contrast).
7 ERROR CODES
DISPLAY ERROR DESCRIPTION
Output voltage and current null, probably a
short circuit occurred between + and -.
Err 10
Switch off and on again the machine, holding
in your hand the torch to avoid it any contact.
Err 53 Torch button pushed at machine start-up.
Output tension and current null, probably a
short circuit occurred between + and -.
Err 54
Switch off and on again the machine, holding
in your hand the torch to avoid it any contact.
Wire feeding problem (nozzle or sheath
Err 57
obstructed, torch cable too long, etc.)
Err 61 L1 phase too low
Err 63 L2 phase too low
art.
DISPLAY
Err 65
H2O
WATER UNIT
LOW
PRESSURE
In the case of an error code different from those listed
please contact technical service
8 MAINTENANCE
Periodically make sure that the welding machine and all
connections are in good condition to ensure operator safety. After
making a repair, be careful to arrange the wiring in such a way that
the parts connected to the power supply are safely insulated from
the parts connected to the welding circuit. Do not allow wires to
come into contact with moving parts or those that heat up during
operation. Mount the clips as on the original machine to avoid, if a
conductor accidentally breaks or disconnects itself, the occurrence
of a connection between power supply and the welding circuits.
10
ERROR DESCRIPTION
L3 phase too low
Cooling pump problem (pressure switch)