Start-Up Procedure; A) Attaching The Wand To The Quick-Connect; Adaptor On The Machine; B) Filling The Tank And Purging The Line - Walter Surface Technologies SURFOX 205 Manual De Usario

5

Start-up procedure

Start-up procedure

A) Attaching the wand to the quick-connect

adaptor on the machine

i.) When an extension cord is needed, use wire size
14 (AWG) for up to 50 feet (15 meters) and size 12 (AWG)
for 50 to 100 feet (15 to 30 meters).
ii.) Connect the hose to the quick-connect adapter on the
machine by turning the part on the hose clock-wise and
making sure that the white dot ends in the locked position.

B) Filling the tank and purging the line

Fill the reservoir in the back of the machine with SURFOX
electrolyte solution. The tank holds 1.9 L of SURFOX
electrolyte solution. Then purge the unit of the testing
solution. Select the highest level of automatic flow and
make sure to let liquid flow for 2 minutes. The machine will
stop after 30 seconds when no current is flowing through.
This mean you will have to press the ON button on the
large wand 4 times to complete the purge.

C) Connecting the air supply

Connect the air supply at the back of the machine. Note
that the maximum allowed pressure is 150 PSI max.,
80 PSI min. (1000 KPa). If the air supply is not plugged into
the machine, the machine will still work but there will not be
any fume elimination.

D) Plugging in the ground clamp

Plug the ground clamp at the front of the unit. Attach the
clamp to the work piece being cleaned. The cleaning and
passivating process will not work if the part is not properly
grounded.

E) Plugging in the power cord

When an extension cord is needed, use wire size 14 (AWG)
for up to 50 feet (15 meters) and size 12 (AWG) for 50 to
100 feet (15 to 30 meters).
8
Tank
Air supply
connector
Ground
clamp