Braun Silk-epil 3 3-410 Manual Del Usuario página 11

you first shave (see section B) and then
epilate the shorter, regrowing hair a week
later.
Fine, re-growing hair might not grow up
to the skin surface. The regular use of
massage sponges (e.g. after showering)
or exfoliation peelings help to prevent
in-growing hair as the gentle scrubbing
action removes the upper skin layer and
fine hair can get through to the skin
surface.
Description
1 Massaging rollers attachment
2 Epilation head with tweezer element
3 Release buttons
4 On/off switch with incorporated light
5 Socket
6 Special cord set
7 Shaver head attachment with trimmer
cap
A How to epilate
• Your skin must be dry and free from
grease or cream.
• Before use, make sure that the epilation
head (2) is clean.
To turn on the appliance, slide up the on/
off switch (4):
Setting «I»: extra gentle
Setting «II»: extra efficient
When switched on, the switch light illumi-
nates the area to be epilated.
Rub your skin to lift short hairs. For opti-
mal performance, hold the appliance at
a right angle (90°) against your skin and
guide it without pressure against the hair
growth, in the direction of the switch.
The massaging rollers (1) stimulate the
skin before and after the hair is pulled out
for an extra gentle epilation experience.
Leg epilation
Epilate your legs from the lower leg in an
upward direction. When epilating behind
the knee, keep the leg stretched out
straight.
Underarm and bikini line epilation
Please be aware that especially at the
beginning these areas are particularly
sensitive to pain. Therefore, we recom-
mend that you start with switch setting
«I». With repeated usage the pain sensa-
tion will diminish.
Before epilating, thoroughly clean the
respective area to remove residue (like
deodorant). Then carefully dab dry with a
towel.
When epilating the underarm, keep your
arm raised up and guide the appliance in
different directions.
Cleaning
After epilating, unplug the appliance,
remove the massaging rollers and clean
the epilation head (2).
Thoroughly clean the tweezer element
using the cleaning brush dipped into
alcohol. While cleaning, you can turn the
tweezer element manually.
To remove the epilation head, press the
release buttons (3) on the left and right
and pull it off. After cleaning, place the
epilation head and the massaging rollers
back on the housing.
B How to use the shaver
head
(7)
a Trimmer cap
b Shaver foil frame with long hair
trimmer
c Release bars
d Cutter block
e Shaver head base
Remove the epilation head and attach
the shaver head (7) by clicking it in (the
long hair trimmer should be in front).
Remove the trimmer cap (a). When using
the shaver head, always select switch
setting «II».
11