Rapid Ct Setup - ITALFARAD PFC144evo Manual De Uso


Once you reach the last parameter of the menu, by pressing
selection.

Using
E
N

Alternatively, from within the programming, holding
directly.

If the user does not press any key for more than 2 minutes, the system leaves the setup automatically and goes back to
normal viewing without saving the changes done on parameters (like EXIT).

N.B.: a backup copy of the setup data (settings that can be modified using the keyboard) can be saved in the
eeprom memory of the PFC144evo regulator. This data can be restored when necessary in the work memory. The
data backup 'copy' and 'restore' commands can be found in the Commands menu.

When the CT value is not known and only used at the moment of the installation, the P.01 parameter for CT
primary can remain set at OFF while all the others can be programmed.

In this case, during the system installation and once the controller is powered up, the display will show a flashing CT
(Current Transformer). By pressing

Once programmed, press
mode.
Tel.+39 051 6618311 Fax +39 051 6605594 E-mail: italfarad@italfarad.com Web: www.italfarad.com
select SAVE to save the changes or EXIT to cancel.

Rapid CT setup

to confirm. The unit will store the setting into P.01, and directly restart in automatic
ITALFARAD S.p.A. via IV novembre n.1 Minerbio Bo Italy
once more will return you to the submenu
for three seconds will save the changes and exit
the CT primary can be set directly.
46