GreenWorks GD24X2BCBK4 Manual Del Operario página 7

4. Tighten the screws.
3.3 ASSEMBLE THE SHAFT
Figure 3.
1. Loosen the screw on the coupler.
2. Push in the release button on the lower shaft.
3. Align the release button with the positioning hole and
slide the two shafts.
4. Turn the lower shaft until the button locks into the
positioning hole.
5. Tighten the screw with the hex wrench.
3.4 ATTACH THE AUXILIARY
HANDLE
Figure 4.
1. Loosen the central knob.
2. Remove the cap and the lower support.
NOTE
Do not miss the spring in the support.
3. Put the auxiliary handle in the lower support.
4. Put the cap to the lower support.
5. Put the entire block in its housing on the shaft.
6. Set the auxiliary handle in the comfortable position.
7. Lock the auxiliary handle with the central knob.
3.5 INSTALL THE BATTERY PACKS
Figure 5.
WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery packs.
• Use only 24V battery packs. Do not use dual-voltage
24/48V battery packs.
• Both battery packs should be installed in the
compartments in order to start the machine.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
4. Do the same operation with the other battery pack.
English
Optimize the power and performance of your new
2x24V machine by running with both battery packs
charged to 100%. If each battery has a different charge
state, the run-time of the machine is subject to the lowest
powered battery (For example: one battery is charged
100%, and the other is charged 50%, the unit will only
run until the 50% battery is depleted).
3.6 REMOVE THE BATTERY PACK
Figure 5.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4 OPERATION
Before you operate the machine, read and understand the
safety regulations and the operation instructions.
Be careful when you operate the machine.
4.1 START THE MACHINE
Figure 6.
1. Push the lock-out button and pull the trigger.
2. Push the speed switch to the desired operating speed.
Push the speed switch to position 1 for low speed or
position 2 for high speed.
4.2 STOP THE MACHINE
Figure 6.
1. Release the trigger to stop the machine.
4.3 OPERATION TIPS
Figure 7.
Keep clearance between the body and the machine.
Do not operate the machine without guard in place.
Follow these tips when you use the machine:
• Keep the machine connected to the correctly worn
harness.
• Keep a firm hold with two hands on the machine while
you operate the machine.
• Cut tall grass from the top down.
7
NOTE
IMPORTANT
WARNING
WARNING
WARNING
EN