Hitachi ATW-IOT-01 Manual De Instrucciones página 11

SAFETY SUMMARY
1. SAFETY SUMMARY
!
DANGER
• Adhere to the electrical standards in effect,
as well as the following points:
• It is imperative to switch off the power
supply of the unit to which the device will
be connected to, before proceeding to
installation. Risk of electric shock.
• Do not install ATW-IOT-01 outdoors.
• Ensure that there is no dust on the
connection points such as the power
terminals and/or on the cable. This may
cause a fire or electric shock.
!
CAUTION
• This appliance must be used only by adult
and capable people, having received the
technical information or instructions to
handle properly and safely this appliance.
• Children should be supervised to ensure that
they do not play with the appliance.
• The device power supplier must be a fixed
installed wiring with an additional circuit
breaker for power switch ON/OFF when
required.
• Local or national regulations must be
followed at all times during the preliminary
work to prepare the electric power line for
the equipment.
• Avoid falls and collisions.
• Never attempt to immerse the product in
liquid.
• Do not use abrasive products or solvents to
clean the casing. Its surface may be cleaned
using a soft, dry cloth.
• Do not attempt to open the casing.
• Do not install the gateway where persons
wearing a pacemaker may be present.
• All use or modification of the equipment
not anticipated by Johnson Controls-Hitachi
Air Conditioning Spain, S.A.U. could lead to
danger in using it.
• Use only the cables and accessories supplied.
PMML0635 rev.3 - 04/2024
2. FACTORY SUPPLIED
ACCESSORIES
Description
ATW-IOT-01 (gateway)
Screw and plug
Installation and
operation manual
3. INSTALLATION

NOTE
• Avoid positioning the receiver against or
close to any metallic part in order to avoid
any WI-FI transmission drop.
• Also make sure that there is strong WI-FI
signal reception at the place of product
placement to ensure proper data transfer
with the cloud. In case WI-FI signal is weak
boost it up by means of a WI-FI range
extender.
• Install the device close to the unit to be
controlled, in a way that the device can be
dismantled if necessary. The product should
be installed at a height of less than 1.5m
high.
• Do not install the receiver where devices
using radio frequencies as means of
transmission are prohibited (Refer to local
standards in effect).
• Do not install the receiver close to devices
that may be affected by radio waves.
• Do not install the receiver in a damp
environment (for example, a bathroom).
Quantity
1
2
1
EN
1