Publicidad
Idiomas disponibles
Idiomas disponibles
The unit can be turned
on at a specified
time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly.
1
2
3
4
Press TIMER to display
~,
then press ENTER
within 6 seconds.
@ is
displayed
and the hour flashes.
y
If you press
ENTER after 6
seconds,
another
operation
may
start.
Designate the hour of the timer-on time by turning
MULTI JOG, then press ENTER.
Repeat to designate
the minute of the timer-on
time.
After you designate
the timer-on time, one of the source names
flashes
on the display.
Press one of the function
buttons
to select
a
source, then press ENTER.
lfTUNER/BAND is pressed, the band cannot be selected
in
this step.
Select the duration for the timer-activated
period
with MULTI JOG, then press ENTER.
5
6
7
Prepare the source.
To listen to a
CD,
load the disc to be played first on tray 1,
To listen to a ta~e,
insert the tape into Deck 1 or 2.
To listen to the radio,
tune in to a station.
Press POWER to turn the unit off after adjusting
the volume and tone.
@ remains
on the display
after the power is turned
off (timer
,~;,
Get ready for the TAPE function
or the timer
recording.
To listen to the tape,
press ~.
To record the source,
press
on Deck 1
When
the timer-on
time
is reached,
the unit turns
on and
begins
play with the selected
source.
The volume
level is automatically
set to 16 when the power is
turned
off with the volume
level set to 17 or more.
The timer recording
period and tape length
When the length
of the tape to be recorded
is shorter
than the
timer recording
period,
on Deck 1 is released
before the timer
is off.
When the tape length is longer than the timer recording
period,
is not released.
If
is not released
for a long time, the tape
in the deck may be damaged.
Press 9/4
to release
.
To check the specified time and source
Press
TIMER. The
timer-on
time, the selected
source name and
the duration
for the timer-activated
period
are displayed
for 4
seconds.
To cancel timer standby mode temporarily
Press
TIMER repeatedly until @ disappears on the display.
To restore the timer standby mode, press TIMER once or twice
to display @.
Using the unit while the timer is set
You can use the unit normally
after setting the timer.
Before
turning
off the power,
carry out step 5 to prepare
the
source,
and adjust the volume
and tone.
Timer
playback
and timer recording
will not begin
unless the
power is turned
off.
" Connected
equipment
cannot be turned on and off by the built-
in timer of this unit.
Use an external
timer.
*
H
and
w
are
a/so
avaj/ab/e instead of MuLT/
JOG.
*
IISET is also available in stead of ENTER.
The duration for the timer-activated
period can be set between
5 and 240 minutes
in 5-minute
steps.
ENGL/SH
14
Publicidad
