RIDGID 916 Manual página 8

916 Roll Groover
Figure 2 – Tighten Set Screws
Installing on 535A, 535M, 1822-I or 300
Compact Threading Machines Mounted
on 100, 150 or 200 Stands
NOTE! 535 Threading Machines use the Model 916
Catalog No. 60382. Attached to the groover is a
mounting plate that properly positions the unit on
the rails of the 535.
NOTE! 1822I and the 300 Compact Threading Machines
use the Model 916 Catalog No. 48307. The lower
roll housing is specifically designed for mounting
of the rails of these machines.
1. Position carriage towards front chuck and swing car-
riage tools to the rear position.
CAUTION Position reamer inside the die head to
prevent accidental contact.
2. Fully OPEN front chuck.
3. Place 916 on far side of carriage rail, lower onto
front rail (Figure 3).
4. Position base so that drive bar feeds into open chuck
and tighten front chuck onto drive bar.
WARNING Drive bar must be centered in front jaws.
Figure 3 – Mounting on No. 1822-I Threading Machine
(Same applies to Models 300 Compact and
535 Threading Machines)
6
Installing on 1822-I Threading Machine
Mounted on 1406 Stand
NOTE! 1822I Threading Machines use the Model 916
Catalog No. 48307.
1. Position carriage towards front chuck and swing tools
to the rear position.
Position reamer inside the die head to
CAUTION
prevent accidental contact.
2. Front chuck must be open. Position 916 so that the
base slides onto the support rails and drive bar feeds
into open chuck.
WARNING Drive bar must be centered in front jaws.
3. Tighten chuck jaws securely onto drive bar.
Installing on 300 Compact Threading
Machine with the 250 Stand.
NOTE! 300 Compact Threading Machines use the Model
916 Catalog No. 45007 and Adapter Bracket
No. 67662 when mounted on a 250 Stand.
1. Position carriage towards front chuck and swing car-
riage tools to rear position.
Position reamer inside the die head to
CAUTION
prevent accidental contact.
2. Place the adapter bracket onto the rails of the 300
Compact and lock into place using the attached pin
(Figure 4).
Adapter bracket must be used with the
WARNING
250 Stand to provide clearance for the pipe. Failure to
use this bracket will result in the pipe hitting the stand.
Figure 4 – Attaching Adapter Bracket to 300 Compact
Threading Machine
3. Place the 916 on the arms of the adapter.
4. Position base so that the drive bar feeds into the
open chuck.
999-998-693.10_REV. B