Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting tool bits
Warning: before do it, make sure unplug the machine!
Fig1
Clean the shank of bit and put some grease
The assembly of bit without the shoulder(with groove) (see Fig 1 & Fig 2)
Operate the lock part 2 to 150 Degree position, insert the bit 1 into the holder 3.
Operate the lock part 2 back, pull the bit 1 to check if it was locked.
When disassembling, repeat operating lock part 2 to 150 Degree as Fig 1, then pull out the bit from holder 3.
The assembly if bit with shoulder ( see Fig 3 & Fig 4)
The shank length can be 160mm(6 3/8 inch) (Length from shank end to the shoulder)
Operate the lock part 2 to 210 Degree position, insert the bit 1 into the holder 3.
Operate the lock part 2 to180 degree position, can lock the bit. Attention: The shoulder position should be between lock part
2 and holder 3.
Operate the lock part 2 back, pull the bit 1 to check if it was locked.
When disassembling, repeat operating lock part 2 to 210 Degree as Fig 3, then pull out the bit from holder 3.
Remarking: When you removing the accessory, such as a bull point, a cutter etc.., follow above procedure in reverse order.
4. Operation
Prior to operation
1. Power source
Ensure that the power source to be utilized conforms to the power requirements which specified on the name plate of the
hammer.
2. Power switch
Ensure that the power switch is in the position of OFF. If the plug is connected to power receptacle while the power switch
is in ON position, the demolition hammer will start operation immediately, which can cause serious accident!
KEEP WORKiNG
KEEP WORKiNG
Keep Working
Keep Working
Fig2
Fig3
08
01
D H
7 5 3 1
Fig4
Publicidad
