During Work; Assembling The Unit - Stihl FW 20 Instrucciones De Servicio

English

During work

Sweep debris from the path of the wheel
as debris may cause flexing of the
abrasive wheel. This could result in high
frictional forces and thus greatly reduce
the engine power available for the actual
cutting work. Always use the cart to cut
in a straight line.
!
Warning !
If the cart is pushed over objects, the
abrasive wheel may become wedged in
the cut and shatter! Always clear a path
for the cart and never work on uneven
surfaces.
!
Warning !
To reduce the risk of injury from a cart
and cut-off machine tipping over and
subsequently causing wheel damage do
not work on uneven surfaces.
12
!
Warning !
Use of this product can generate dust,
mists and fumes containing chemicals
known to cause serious or fatal injury or
illness. Control dust, mists and fumes at
the source where possible. A water
attachment kit is available for your cart
and cut-off machine and should be used
for dust suppression when wet cutting is
feasible. When the inhalation of dust,
mists and fumes cannot be eliminated,
the operator and any bystanders should
always wear a respirator approved by
NIOSH / MSHA for the material being
cut. See also the safety precautions on
dust, mists and fumes in the Owner's
Manual of the cut-off machine.
For information on transporting,
maintenance, repair and storage of your
cut- off machine, see specific sections of
your cut-off machine manual.

Assembling the unit

Move cart into working position
: Turn star handle (1) anticlockwise
and move guide tube (2) to working
position A.
:
Tighten star handle down in
clockwise direction.
:
Steady the guide tube.
:
Move the lever (3) for cutting depth
adjustment to position A –
the cutting depth adjustment is
released.
FW 20