JB Systems Light GALAXY LED Manual De Instrucciones página 5

ENGLISH
3. DMX-mode:
When the units are connected in DMX-mode, they can be controlled using the DMX-chart:
OPERATE THE UNIT BY CA8 OR RF8SET
When used in standalone or master/slave mode we strongly advise
you to use the CA-8 "Wired easy controller" or RF-8SET "Wireless
easy controller".
 CA-8 wired remote: Connect the controller to the jack input of
the first unit (master).
 RF-8SET wireless remote: the wireless remote has two parts:
 RF-8T: small RF-transmitter that can control up to 5 effects.
 RF-8R: small RF-receiver that should be connected to the
DIN 5-pin input of the GALAXY. See the installation manual
of the receiver for more information.
Now you can control all the connected units:
STANDBY BUTTON:
Press this button to start/stop blackout mode on all connected units.
MODE/FUNCTION BUTTONS:
With the MODE button you can select 3 different modes:
STAND BY
Strobe
1. Synchronous strobe in 1. Red
white 2. Green
2. Sound strobe in white 3. Blue
3. Sound strobe in color 4. White
5. Red + Green
6. Red + Blue
7. Red + White
FUNCTION 8. Green + Blue
9. Green + White
10. Blue + White
11. Red + Green + Blue
12. Red + Green + White
13. Red + Blue + White
14. Green + Blue + White
15. Red + Green + Blue + White
16. Color change by sound
MODE
Sound (LED OFF) Manual Color (LED ON)
JB SYSTEMS
®
OPERATION MANUAL
Blackout the unit
Select color Select Show
1 – 6
Show (LED slow blinking)
5/41 GALAXY
ENGLISH
MAINTENANCE
 Make sure the area below the installation place is free from unwanted persons during servicing.
 Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
 The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
 In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
 The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
 The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics.
 Clean with a soft cloth using normal glass cleaning products. Always dry the parts carefully.
 Clean the external optics at least once every 30 days.
 Clean the internal optics at least every 90 days.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
SPECIFICATIONS
Mains Input: AC 100 - 240V, 50Hz/60Hz
Fuse: 250V T2A
Power consumption: 30 Watt
Sound Control: Internal microphone
Lamp: 2x 10W RGBW LED
Size: 344 x 350 x 152mm
Weight: 5 kg
Every information is subject to change without prior notice
You can download the latest version of this user manual on our website: www.beglec.com
JB SYSTEMS
®
OPERATION MANUAL
6/41 GALAXY