Elite XTREME XiD19 Manual De Usuario página 22

X i D 1 9
Keep Working
DISPOSAL OF EXHAUSTED BATTEY PACK
To preserve natural resources, please recycle or dispose of the battery pack properly. This battery pack contains lithium-ion batte-
ries. Consult your local waste authority for information regarding available recycle and/or disposal options. Discharge your battery
pack by operating your drill, then remove the battery pack from your drill housing and cover the connections with heavy duty adhe-
sive tape to prevent short circuit and energy discharge. Do not attempt to open or remove any components.
Environment
Do not dispose of battery packs/batteries into household waste, fire or water. Battery packs/batteries should be collected, recy-
cled or disposed of in an environmental-friendly manner. Batteries need to be removed before disposal and disposed of properly.
Place the battery(s) in asuitable packaging to ensure that the terminals cannotbe short-circuited. Take them to any authorised
repairagent or a local recycling station.
This marking indicates that this product should not be disposed with otherhousehold wastes. To prevent possible harm to the envi-
ronment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material
resources. To return your used device, please use the return and collection systems or contact the retailer where the product was
purchased. They can take this product for environmental safe recycling.
PROBLEM SOLUTION
1. WHY DOES THE DRILL NOT TURN ON WHEN YOU PRESS THE SWITCH?
The forward/reverse rotation control, which is on top of the trigger, is positioned in the lock function. Unlock the forward/reverse
rotation control by putting it into the required rotation position. Push the trigger and the drill will start to rotate.
2. THE DRILL STOPS BEFORE THE SCREW IS COMPLETELY TIGHTENED.WHY?
Verify the torque position of the variable clutch, you can find the variable clutch between the chuck and the drill body. Position 1
is the lowest torque (screw driving force) and position 16 is the highest torque (screw driving force). Position 17 is for drill operation.
Regulate the variable clutch to a higher position to reach the best result
3. I CANNOT FIT THE BATTERY INTO THE BATTERY CHARGER.WHY?
The battery can be inserted into the charger only in one direction. Turn the battery arounduntil it can be inserted into the slot.
4. REASONS FOR DIFFERENT BATTERY PACK WORKING TIMES.
Charging time issue, as above, and having not used a battery pack for a prolonged time will reduce the working life of the battery
pack. This can be corrected after several charge and discharge operations by charging&working with your drill. Heavy working
conditions such as large screws into hard wood will use up the battery energy faster than lighter working conditions. Do not
re-charge your battery pack below 0° and above 50° as this will affect performance.
5.HOT BATTERY PACK PROTECTION
The normal charging temperature is between 0° and 50°.When the battery pack is too hot, it automatically starts a HOT battery
pack delay, and suspends charging until it has reached the correct temperature. The charging process will then automatically
begin.
KEEP WORKiNG
08