TO CHANGE
AIR FILTER
1. Remove
the air filter by turning
counter-clockwise
to the stop and pull
away from collar.
2.
Remove
filter from inside of cover.
3. Clean the inside of the cover and the
collar to remove
any dirt accumula-
tion.
4.
Insert new filter into cover.
5.
Put air filter cover and filter into collar
aligning
the tab with the slot.
6.
Push in on cover and turn clockwise
to
tighten.
Collar
Clip
Turn counter-
clockwise to
remove
Air filter
Air filter cover"
Turn
=lockwise
to tighten
MUFFLER
Inspect and replace corroded muffler as it
could create a fire hazard and/or dam-
age.
SPARK
PLUG
Replace spark plugs at the beginning of
each mowing
season or after every 100
hours of operation, whichever occurs first.
Spark
plug type and gap setting
are
shown in "PRODUCT
SPECIFICATIONS"
in Maintenance
section
of this manual.
CLEANING
IMPORTANT:
For best performance,
keep
mower housing
free of built-up grass and
trash. Clean the underside of your mower
after each use.
_,CAUTION:
Disconnect spark plug wire
from spark plug and place wire where it
cannot come in contact with the spark
plug.
• Clean the underside of your lawn mower
by scraping to remove build-up of grass
and trash.
• Clean engine often to keep trash from
accumulating.
A clogged engine runs
hotter and shortens engine life.
• Keep finished surfaces and wheels free of
all gasoline, oil, etc.
• We do not recommend
using a garden
hose to clean lawn mower unless the
electrical system, muffler, air filter and
carburetor are covered to keep water out.
Water in engine can result in shortened
engine life.
CLEAN
UNDER
DRIVE
COVER
Clean under drive cover at least twice a
season.
Scrape underside of cover with
putty knife or similar tool to remove any
build-up of trash or grass on underside of
drive cover.
• I,CAUTION:
Before performing
any
service
and adjustments:
1. Release
control bar and stop engine.
2.
Make sure the blade and all moving
parts have completely
stopped.
3.
Disconnect
spark plug wire from spark
plug and place where it cannot come
in contact with plug.
LAWNMOWER
TO ADJUST cu'n'ING
HEIGHT
See "TO ADJUST CUFFING HEIGHT" in the
Operation secUon of this manual.
REAR DEFLECTOR
The rear deflector, attached between the rear
wheels of your lawn mower, is provided to
minimize the possibility that objects will be
thrown out the rear of the lawn mower into the
operator's mowing position.
If the rear
deflector becomes damaged, it should be
replaced.
13